Replacement Rear Taillights and Clearance Light Bar for Boat Trailer

Question

Question:

HI there! The some of the led lights of my boat trailers are not working. Likely, they got wet when I launched the boat. What is the best way to fix the problem? Thanks! GF

asked by: Gonzalo F

0

Expert Reply:

The lights will need to be replaced, we have some great options for this. The Optronics LED Combination Trailer Tail Lights part # TLL160RK looks to be a great match for your existing taillights and the Custer Trailer LED Clearance Identification Light Bar part # CPL26R-3BAR looks to be a great replacement for the rear light bar. These are LED's so they will burn brighter and last longer than incandescent.

expert reply by: Conner L

0

Replacement Rear Taillights and Clearance Light Bar for Boat Trailer
(click to enlarge)

Answer 1

In order to find the correct replacement fender for a trailer you'll need to know the wheel size. The CE Smith Single Axle Trailer Fender part #CE17960ATB seems to be a goof match but it's for 13" wheels. If this is not the size you have…

view full answer...

Answer 2

The bolt pattern of the Electric Trailer Brake Assembly #AKEBRK-35L that you referenced is 4 on 4 inch. If you check out the picture I attached you will see all the dimensions of the flange. You might try measuring yours again to be certain as it…

view full answer...

Answer 3

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 4

The amount of bow that's put into trailer axles like the #7359765 is based on about how much a trailer is typically going to weigh that has a 3,500 lb capacity. So there's a bit of approximation and obviously it can't be totally perfect…

view full answer...

Answer 5

While trailer axles do feature an upward bend like you are describing, there isn't a particular amount/measurement that is standard across the board. This bend in the axle is designed so that it will straighten under a trailer's loaded…

view full answer...

Answer 6

I recommend replacing an entire ladder if it's damaged. You'll want to find a replacement based on the height. Such as the Stromberg Carlson #LA-401 that is 99-1/2 inches tall. They can be cut shorter to customize the length if needed.

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

The Thule WingBar Evo Crossbar System part #TH711520, part #TH480R, and part #THKIT1803 while installed on your 2019 Toyota Highlander will indeed need to be positioned so that the door clip is located 13-1/4" back from the rubber molding…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

In order to install the Tekonsha Prodigy P3 Trailer Brake Controller part #90195 on a 2016 Toyota Tacoma you'll need the Tekonsha Custom Wiring Adapter for Trailer Brake Controllers part #3031-P which makes for a plug-in-play installation.

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

We have the Optronics Incandescent #MC65RB and Optronics Thinline LED #MCL75RB that use a red lens. The Optronics Incandescent #MC65AB and Optronics ThinLine LED #MCL75AB have an amber lens. A Optronics ThinLine LED #UCL65CB uses a clear lens with…

view full answer...

Replacement Rear Taillights and Clearance Light Bar for Boat Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching