What Are The Mounting Hole Measurements For The Buyers Products Super Track Kit

Question

Question:

What are the measurements for the mounting holes ?

asked by: David L

1

Helpful Expert Reply:

The Buyers Products Super Track Kit - 4 Clear Anodized Extruded Aluminum Rails With 8 Tie Rings, part # 337ST93, has the following mounting hole measurements.

From the end of the bracket to the closest hole, 9/16" (from both ends)
From first hole to next hole on the bracket, 5" (from both sides)
Distance between other holes, 6"

I have included a video review link and a picture showing these measurements below.

expert reply by: Mark Smith

1

Buyers Products Super Track Measurements
(click to enlarge)

Answer 1

The inlet and discharge threading on the Flow Max RV Fresh Water Pump - 12 Volt #LC689052 is .825 inches using a digital caliper so it is not the 1/2 inch male national pipe thread which would be .840 inches. Lippert recommends using the barb…

view full answer...

Answer 2

I contacted buyers are there are not any installation instructions available at this time for the Buyers Products Super Track Kit part #337ST93. I went to the warehouse and made sure the rings in our stock would snap into the track. Depress the gold…

view full answer...

Answer 3

It might be possible to use the Long Bed Yakima SideBar Side Rails #Y01154 for the OverHaul Rack #Y01151-57 on your Ford F-150 Raptor with the short bed but it's going to depend on how much space you have between the uprights when they're…

view full answer...

Answer 4

The centerline on the #BR27FR is going to be from the center of the hitch pin hole. If you draw a line straight out and measure the distance to the bottom of the hook that is 1". I have attached a diagram below for your reference.

view full answer...

Answer 5

I recommend using the Curt Lock Set #C23556 for your Curt Adjustable 2-Ball Mount #C99NR. This comes with a lock for the hitch receiver and one for the ball mount platform. Even though your platform uses 2 pins, only 1 locking pin is needed to secure…

view full answer...

Answer 6

The best way to power the interior lights in your trailer is with its own independent battery. You will not want to use the breakaway battery. The breakaway battery is only designed to operate the breakaway and will drain extremely quickly,…

view full answer...

Answer 7

Stainless steel hardware would be the best type to use when installing the Tow-Rax Low-Profile Floor Track for Tie-Down Anchors #TWSP72TA to prevent corrosion.

view full answer...

Answer 8

Tow-Rax Low-Profile Floor Track for Tie-Down Anchors - Aluminum - 6' Long - Machined - Qty 1 #TWSP72TA. This system when using the Tie-Down Anchor for Tow-Rax Low-Profile Floor Track - 1,666 lbs - Qty 1 #TWSPDSTD225 have a working limit of the…

view full answer...

Answer 9

I have a good solution for you. While the black tapered is not available in that length the Tow-Rax Low-Profile Floor Track for Tie-Down Anchors part #TWSP72TA uses the same tie downs like the Tie-Down Ring for Super Track System part #337LR1 or the…

view full answer...

What Are The Mounting Hole Measurements For The Buyers Products Super Track Kit

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching