Replacement Axle With A 95 Inch Hub Face
Question:
my hub to hub is 95 but spring center to center is 78?
asked by: Steve S
0
Expert Reply:
The correct replacement for you 95 inch hub face measurement is The Trailer Axle Beam with Easy Grease Spindles - 95 inch Long - 7,000 pounds # e88GR. The spring centers are 80 inches apart so you will have to remove them and weld new spring seats to the locations that you measured using The Spring Seat # TRSS300. The spring center is measured from the center of each seat.
I attached a review video link below.
expert reply by:
Noah E
0
Products Referenced in This Question
Spring Seat for Typical 5,200-lb to 7,200-lb, Round Trailer Axles with 3" Diameter
- Trailer Suspension Parts
- Spring Seats
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Round Axle - 3 Inch
- TruRyde
more information >
Product Page this Question was Asked From
Trailer Axle Beam with Easy Grease Spindles - 95" Long - 7,000 lbs
- Trailer Axles
- Leaf Spring Suspension
- Easy Lube Spindles
- No Hubs
- 7000 lbs
- Spindles Only
- 80 Inch Long
- 95 Inch Long
- No Drop or Lift
- etrailer
more information >
Continue Researching
- Q&A: Wiring Diagram for Bargman 7-Way RV Style Connector # WG54006-043
- Q&A: Picking Out Replacement Axle for Snowbear 550LHD Trailer
- Article: RV Electrical Power Systems
- Article: How to Charge RV Batteries
- Article: Most Popular Wheel Bearings
- Q&A: Issue with Bearing Buddy Leaking Grease from Overfill Port
- Q&A: Greystone Fireplace WF2613R Replacement for RV
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Article: Best Camper Jacks
- Q&A: Is there a Replacement for Dexter Nev-R-Lube Hub 008-386-80
- Q&A: How to Determine the Distance for Mounting Trailer Spring Hangers on a Single Axle Trailer
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)