Replacement Ceiling Garnish For MaxxAir MaxxFan Deluxe RV Roof Vent

Question

Question:

Hi, Ive broken my inner plastic trim for the max fan delux and wondering if you have the replacement thaks

asked by: Stephen B

0

Expert Reply:

It sounds like you're looking for a replacement ceiling garnish for your MaxxAir MaxxFan RV roof vent. If that's what you're after, we have the Ceiling Garnish for MaxxAir MaxxFan RV Roof Vent # MA54FR.

This garnish will fit the MA00-04000K, MA00-04002K, MA00A04301K, MA00A04401K, MA00-04500K, or MA00-04751KSX roof vents.

expert reply by: Bryce D

0

Answer 1

Yes, you can keep the Kat's Heaters Thermal Battery Wrap #KH22300 plugged in for an extended period of time like you mentioned.

view full answer...

Answer 2

It sounds like you're looking for the Ceiling Garnish for MaxxAir Maxxfan RV Roof Vent #MA54FR, and will fit a standard vent opening of 14" x 14".

view full answer...

Answer 3

Since you have a MaxxFan on your Winnebago Travato the garnish part #MA54FR that you referenced would fit and work well.

view full answer...

Answer 4

The ceiling garnishes like the MaxxAir Maxxfan RV Roof Vent - White item #MA54FR you were looking at are universal. So long as you have the standard 14"x14" opening for your MaxxAir 4501k this garnish will be able to fit. It may require…

view full answer...

Answer 5

When it comes to trimming The Ceiling Garnish for MaxxAir MaxxFan RV Roof Vent #MA54FR you will need to use masking tape to mark where you want to make your cut on the garnish. You will then need to use a hand saw to cut along the masking tape. I…

view full answer...

Answer 6

The ceiling vent garnishes are pretty universal so as long as you have the standard 14" x 14" vent you should be able to use any of the available garnishes such as the Ceiling Garnish for MaxxAir Maxxfan RV Roof Vent part #MA54FR which is…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Replacement Ceiling Garnish For MaxxAir MaxxFan Deluxe RV Roof Vent

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching