Tuson 1A0650 Replacement Motor

Question

Question:

Need slide out motor for 2012 open range residential. 1A-0650 12-02-03. Also there is a part number 24179

asked by: Diane

0

Expert Reply:

To replace your Tuson 1A0650 motor, I recommend the Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor item # LC196308 you were looking at. This is a heavy duty 6500-pound rated Tuson Landing Gear Motor for fifth-wheel RVs. It is easy to install and shouldn't take long to replace your old motor.

expert reply by: Jerred H

0

Answer 1

Essentially the #LG-196308 and the #LC196308 are identical. I'd go with the lower priced of the two since neither is a better choice than the other.

view full answer...

Answer 2

Given the issue you described and the fact that you have done a good job of troubleshooting and checking other potential sources for the issue, it sounds like the motor is going bad. Since you mentioned the landing gear working fine for a little bit…

view full answer...

Answer 3

It looks like the red LED on the Bright Way Solar Battery Charger - 7.5 Watt Solar Panel #BRW54FR is actively blinking when it's charging the battery so if it's still on then that would indicate it's sending a charge. It's worth…

view full answer...

Answer 4

From the attached image, you have what looks to be an SAE solar plug, a DC connector. This is most likely connected to your battery bank, I suggest you trace the wires. If this does not go through a charge controller, you will need to have one in…

view full answer...

Answer 5

We have just what you need to replace your landing gear motor M9000PK with the #LC196308 and you'd be set! This is a confirmed fit for what you have and is a faster motor too so your jacks will raise and lower quicker.

view full answer...

Answer 6

I reached out to my contact at Lippert and since your landing gear motor is blowing a fuse as soon as it sees load he mentioned the issue is more than likely that the motor is not getting the correct voltage, with the less common cause being the…

view full answer...

Answer 7

From what I could find it looks like your ADTH 1RV-200 motor has a weight capacity of 6,500 lbs. You can use a motor that is rated for a higher capacity, like our replacement motor #LC142178 for Ram landing gear which is rated at 8,000 lbs. Just keep…

view full answer...

Answer 8

The Stromberg Carlson Replacement Motor #LG-196308 and the Lippert HD Motor #LC196308 referenced in your question are essentially the same motor. They can be used interchangeably on a landing gear system. With this in mind, I simply recommend…

view full answer...

Answer 9

Hey William, the E6 error on a Furrion wall thermostat indicates an Open circuit Humidity Sensor issue. Most likely the sensor is bad and needs to be replaced as this is a pretty rare error code.

view full answer...

Answer 10

That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…

view full answer...

Answer 11

Hey Johnny, thanks for reaching out! I highly recommend using the Lippert HD 6500-lbTuson 5th Wheel RV Landing Gear Motor #LC196308 as a replacement for your 8532-07 motor. According to my research your motor is rated for 5,500 lbs so this motor will…

view full answer...

Tuson 1A0650 Replacement Motor

Product Page this Question was Asked From

Continue Researching