Where do I Mount My Dial/Control Head for the Tow Pro Elite for My 2022 Chevy Silverado 1500?

Question

Question:

I just bought a Red Arc tow pro. where should I mount my tow pro elite brake controller dial on my 2022 Chevy Silverado 1500?

asked by: Chad G

0

Expert Reply:

When installing the Redarc Tow-Pro Elite # RED44FR on your 2022 Chevy Silverado, it is important to note that the dial/control head is designed to be mounted at a distance from the main unit to allow for a neat, convenient installation and not impeding on lower leg airbags or driver leg room. The remote head can be mounted directly to the dashboard, to the center console, or through a spare knock-out switch panel. This does require for a single drilled hole. I went ahead and attached a picture that shows the installation of the remote head for your convenience.

You can also purchase the Universal Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob # 331-TPSI-001 to create a more factory look at the mounting location.

expert reply by: Bob C

0

Redarc Tow-Pro Elite # RED44FR Dial/Control Head Installation Instructions
(click to enlarge)

Answer 1

Other than the fact that the knob for the Redarc Tow Pro Elite #RED44FR needs to be within the easy reach of the driver, the control knob can be installed wherever you wish. Typically, there are blank knockouts in the dash of most vehicles where you…

view full answer...

Answer 2

I went to the warehouse to measure the Universal Mounting Panel for Redarc Tow-Pro Elite Trailer Brake Controller Control Knob #331-TPSI-001 and found the back was 1" x 1-1/2" and the widest point of the rear knob was 15/16"; this will…

view full answer...

Answer 3

Yes, when installing the knob for the Redarc Tow-Pro Liberty Brake Controller item #RED24FR you will want to remove any extra material behind the insert. I am happy the video was able to help you out. I have linked a couple of pictures from the video…

view full answer...

Answer 4

For you 2017 Dodge Durango, i recommend the Tekonsha Prodigy P2 Brake Controller, #90885. The P2 Brake Controller is a proportional brake controller, so it applies brake power to your trailer in proportion to the brake pressure applied to your…

view full answer...

Answer 5

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 6

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 9

The one really big downside to gooseneck towing is that there isn't a great solution for short bed truck clearance unlike fifth wheel towing. With fifth wheel hitches you can use a slider hitch and have the clearance issue handled. With gooseneck…

view full answer...

Answer 10

Actually our etrailer.com brand brake assemblies are rebranded AxleTek assemblies. So we have the 8k left and right assembly set #AKEBRK-8 which is most likely what you need but these are 12-1/4 inch in diameter by 3-3/8 inches wide and attach with a…

view full answer...

Answer 11

The crank handle for the Lippert Components Spare Tire Winch with Offset Cable item #LC159056, is Replacement Crank Extension for Lippert Spare Tire Winch Assemblies - 35-1/2" item #LC1315411. The Spare Tire Winch item #LC159056 has a 1/2-inch…

view full answer...

Where do I Mount My Dial/Control Head for the Tow Pro Elite for My 2022 Chevy Silverado 1500?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching