Are Konig XD16 Pro Snow Tire Chains Rated For Off-Road

Question

Question:

Are the Konig Snow Tire Chains - Diamond Pattern - D Link - XD16 Pro - Size 280 approved for off road use?

asked by: Jacob F

0

Expert Reply:

The Konig Snow Tire Chains - XD16 Pro - Size 280, # KON64FR that you linked to are on road only. However, there are off-road, and on-road/off-road options available. Please use the fit guide to select your vehicle and tire size to filter the available options.

expert reply by: Michael R

0

Answer 1

With you having 295/60R20 tires on your 2019 Ram 3500 Laramie, it does limit what we have available. With that said, we currently do not have a V-Bar style tire chain available, unfortunately. However, we do have the Konig Snow Tire Chains - XD16 Pro…

view full answer...

Answer 2

You can absolutely use Class S snow tire chains on your 2022 Ram 2500; Class S chains are for vehicles with limited wheel well clearance while Class U chains are for vehicles with more wheel well clearance. For your '22 Ram 2500, the Class S…

view full answer...

Answer 3

The Titan Chain #TC2536 tire chains are confirmed to fit size 275/65-20 tires. However, when I checked the owner's manual for the 2015 Ford F-350, the manual says that tire chains should not be used on 20 inch wheels with your vehicle. Since…

view full answer...

Answer 4

For Toyo Open Country A/T III LT295/65R20 tires you would require the Konig Tire Chains #KON74FR. I've attached a short video below where Lucky will walk you through the installation process.

view full answer...

Answer 5

When using a single set of tire chains on a vehicle that is 4 wheel drive or all wheel drive you want to install the chains on the primary drive axle. Typically this will be listed in the owner's manual. But for a 4WD drive vehicle the axle to…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Are Konig XD16 Pro Snow Tire Chains Rated For Off-Road

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching