Universal 7-Way Connector for 2022 Honda Pilot

Question

Question:

I have a Honda Pilot that has a 4-flat connector. I need a 7-way connector to control my trailer's brakes and use my brake controller with. Do you have one for my vehicle?

asked by: Renee

0

Expert Reply:

Yes, I do have a way to add a 7-way connector to your 2022 Honda Pilot. I recommend the Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires item # ETBC7. The kit includes a pre-wired 7- and 4-way trailer connector that mounts easily at the rear of your Honda with an included bracket. This kit is designed for use on vehicles like yours with an existing 4-way flat trailer connector and plugs directly into it. You will then connect the blue wire to the blue wire on the brake controller, connect the black wire to the positive post on the vehicle's battery, the white wire to ground, and the yellow wire to vehicle's reverse circuit if applicable. This will provide you with the ability to control your trailer's brakes and also provide you with a 12v power wire for you trailer's accessories.

expert reply by: Jerred H

0

Answer 1

It may be easier to find either a grommet or wiring harness that goes through the firewall by looking at it from the motor side on your 2016 Honda Pilot. It may not be obvious where the wiring is going into the engine compartment when looking at it…

view full answer...

Answer 2

If the 7-Way trailer connector on your 2016 Honda Pilot is the factory installed 7-Way then all of the functions, including the 12 volt power circuit, should be active. But on models that did not come with the factory harness the connection and…

view full answer...

Answer 3

The installation of a trailer wiring harness on your 2022 Honda Pilot may seem difficult but it is not as complicated as you would think. The first thing would be deciding on what wiring harness to use, I recommend the T-One Vehicle Wiring Harness…

view full answer...

Answer 4

I would be glad to help! When installing the Curt T-Connector #C56291 on your 2018 Honda Pilot, it looks like the location for the included fuse is the number 2 location in the fuse box that is located near the brake fluid reservoir (near the…

view full answer...

Answer 5

Sine the LED does not light up on your Curt Echo #C51180, that means there's no power getting through to it. Given the fact that the Echo was receiving power and working properly at one point, chances are you're dealing with a poor ground…

view full answer...

Answer 6

I have a few things for you to check when it comes to not being able to pair your iPhone with the Curt Echo #C51180. The first thing to do is make sure that you're pairing your phone with the Echo through the app. If you paired it through the…

view full answer...

Answer 7

Since you are not getting the 12V power when your truck is running, you most likely don't have a fuse issue as you stated their isn't a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at the…

view full answer...

Answer 8

The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Universal 7-Way Connector for 2022 Honda Pilot

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching