Can You Use Weight Distribution On a 2011 Ford Edge
Question:
Can I use a weight distribution hitch on a Ford Edge 2011 with a hitch rating of 400 pounds tongue weight and 4000 towing capacity ? The current tongue weight is 600 pounds.
asked by: Frank
Helpful Expert Reply:
It's not permitted to use a weight distribution system on a 2011 Ford Edge due to the unibody frame construction. That said, if you are simply after ways to fix the rear end sag/squat I have a great option for you in the Air Lift 1000 Air Helper Springs for Coil Springs part # AL60819. These air bags install inside the coil spring so there are no modifications needed and you can fill them with air to expand and provide support when needed. The support is also adjustable so you can get the perfect mix of comfort for any given load.
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Air Springs
- Light Duty
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Video: Trailer Hitch Installation - 2012 Ford Edge - Draw-Tite
- Video: Brophy Mounting Bracket for 4-Pole Flat Trailer Connector Review
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Anti-Rattle Trailer Hitch Receiver Lock for 2" Hitches - 3-1/2" Span
- Shop: Suspension Enhancement
- Video: Air Lift Union T-Piece Review
- Video: Trailer Wiring Harness Installation - 2012 Ford Edge 118515
- Shop: Trailer Wiring
- Q&A: Recommended Trailer Hitch Receiver to Tow a Trailer with a 2012 Ford Edge
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Video: etrailer Class III Trailer Hitch Installation - 2012 Ford Edge
- Video: Master Lock Pivot Lock Hitch Pin Review
- Video: Air Lift Vehicle Suspension - Rear Axle Suspension Enhancement - AL60819 Review
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Shop: Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-1/4" Span
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: No-Drill Mounting Clips for EZ Connector Vehicle-End Trailer Connector - Ford/Toyota
- Shop: Hitch Pin and Clip For 2-1/2" and 3" Hitches - 5/8" Diameter x 4" Span
- Search Results: airbags
- Q&A: Question on Weight Distribution and Sway Control On A 2013 Ford Edge
- Q&A: Rear Suspension Enhancement Recommendation for 2010 Ford Edge Carrying Hitch Carrier
- Q&A: Does Air Line Run Out of the Top or Bottom of Air Bags for a 2010 Ford Edge
- Q&A: Can 2015 Ford Edge Tow 3500-Lb Trailer
- Q&A: Trailer Hitch and Wiring Recommendation for 2014 Lincoln MKX AWD
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Search Results: hitch