Looking For Replacement Hub That Uses Bower Outer Bearing 09067 and Inner Bearing 14130

Question:

looking for to replace entire hub and bearings, races. Outer bearing is a bower 09067 and the inner is a bower 14130. I think it is a 5 on 5inch bolt pattern, but I need to replace rims and tires also, so not concerned with the pattern. It appears to be 1 5/16inch on the inner OD of the spindle and 3/4inch on the outer OD of the spindle. This is a tapered spindle. Do you have anything that might fit?

asked by: LB S

Expert Reply:

I do have a solution for you, but with you having the 09067 outer bearing and 14130 inner bearings, we will not have anything that will replace your hub.

Though you will need to measure a few things to make sure it will work, I recommend replacing the axle. Something like the etrailer.com Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 72" Long - 2,000 lbs # e37YR comes with pre-greased idler hubs that have a 5 on 4-1/2 bolt pattern and will be very easy to get wheels for. However, it will measure 72 inches from hub face to hub face and 58 inches from center of one springe seat to the center of the other, but we do also have different measurement available and I have our axle page linked below.

The size of the tire will also be important as you want to make sure you have at least 3 inches from the top of the tire and bottom of the fender/wheel well. As an example, something like the Kenda Karrier S-Trail ST145/R12 Radial Tire w/ 12" White Spoke Wheel - 5 on 4-1/2 - LR D # AM31199DX will have a diameter of 21.3 inches. You may already have larger tires than this, but you will definitely need to check your clearance if you decide to go larger than your current size.

expert reply by: Lazer S