Will a Toolbox Block the GCH Truck Bed Camera on 2021 F-250 Super Duty

Question

Question:

I have a 2021 F-250 Super Duty and I was looking at truck bed cargo cameras. I think the GCH camera for an 8 inch monitor would work well but I have a tool box in the bed up against the cab. Do you think this will interfere with the camera?

asked by: Jimmy

0

Expert Reply:

Since the toolbox you have is up against the cab it should not pose a problem for the Custom Third Brake Light Camera for 8" Factory Monitor - Night Vision # 3460001. The camera manually adjusts 360 degrees and has a 150 degree viewing angle so even if your toolbox sticks out quite a bit you can adjust the camera accordingly.

I have attached a review video as well as an installation video on a 2017 F-250 Super Duty for your reference.

expert reply by: Robin H

0

Answer 1

According to the owner of GCH Automotive, the #3460001 camera can be ran through a car wash. Just make sure the gaskets are installed properly. If they aren't installed properly, the camera can leak. It's also important that the mounting…

view full answer...

Answer 2

If you want to see the entire install process of the third brake light camera kit #3460001 for your 2020 Ford F-250 check out the linked video on this page. We ran the wiring up to the engine bay area which is the only and best place to run the…

view full answer...

Answer 3

Yes, you can use the Truck Bed Cargo Camera for 8" Factory Monitor - Switch Kit #3460001 that fits your 2016 Ford F-150 with an 8" factory monitor as an observation camera so you can see your truck bed. What you will need to do is simply…

view full answer...

Answer 4

You should be able to wire the power for the camera located at the 3rd brake light so that it has constant power and then it is switched on/off manually. If the current camera doesn't have that capability then you can install the Truck Bed Cargo…

view full answer...

Answer 5

Not a saint, but I should still be able to help you out! I believe you are asking about a standard square roof vent on your trailer, and you really just need to know two things - the size of the cut out of the vent opening and the (approximate) depth…

view full answer...

Answer 6

The Custom Third Brake Light Camera part #3460001 which is a fit for a 2020 Ford F-150 with 8" monitor installs rather easily with only a few connections. There is a plug that ties into the factory harness and then a switch which gets run to a…

view full answer...

Answer 7

While the best and most certain way to tell if your 2018 Ford F-250 has the puck system is to call your local Ford dealer with your VIN, it should be pretty easy to tell otherwise. If your bed looks like the accompanying photo - with four accessible…

view full answer...

Answer 8

I do have a camera system that will tie into the factory in-dash monitor on a 2010 - 2019 Ram 3500 with the Truck Bed Cargo Camera for Factory Monitor part #3460015 but this as I am sure you can see installs on the vehicle and is used predominantly…

view full answer...

Answer 9

If you have the factory auxiliary switch then just wire the Custom Third Brake Light Camera for 8" Factory Monitor - Night Vision #3460001 to that. If you don't have the factory auxiliary switch then you will want to utilize that toggle…

view full answer...

Answer 10

Welcome back! We do not sell the breakers you'll need for the Progressive Dynamics 4100 Series RV Converter item #PD4135K you purchased but I have listed below the ones Progressive Dynamics recommends. You can source them at your local hardware…

view full answer...

Will a Toolbox Block the GCH Truck Bed Camera on 2021 F-250 Super Duty

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching