Installing Weight Distribution System on Trailer with Crossmember Where Hangers Locate
Question:
I am trying to install this system and the farthest I can put the brackets for the trunion bars from the ball is 25 to 26” because my trailer jack is welded in place in the spot I would need to put it to be 31” from the ball. The system says you must have a minimum of 4” of bar past the hanger so is having more bar past the hangar a problem?
asked by: Brian S
Expert Reply:
Since your trailer has a crossmember that prevents the Curt TruTrack weight distribution # C17500 from having it's bar hangers installed in the correct location you are going to have to drill holes and mount the bar brackets to the sides of the trailer frame or have them welded in place.
Product Page this Question was Asked From
Curt TruTrack Weight Distribution System w/ Sway Control - Trunnion - 10,000 lbs GTW, 1,000 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Surge Brake Compatible
- Fits 2 Inch Hitch
- Allows Backing Up
- 900 lbs
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Replacement Brake Shoes for 10 x 1-3/4-inch Brakes on 22-Foot Travel Trailer with 3500-lb Axles
- Q&A: Looking for Replacement Trailer Lamp Lens # 1A-S-20
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Determining Trailer Tongue Weight
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Closest Metric Replacement Tire Size for 7.00-15 Tire on Livestock Trailer
- Q&A: Stamp On 2005 Ford F-150 Says 9,900 Lbs but How Much Weight Can I Tow
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: What 2" Hitch Ball Will Fit The Curt TruTrack 2P Trailer Mounted Weight Distribution System # C67ZV?
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle