What is the Post on the Optronics LED Clearance or Side Marker Light Made From

Question

Question:

I Know the back plate is stainless steel, but is the mounting stud/nut stainless steel too? Picture doesnt look like it. Thanks

asked by: Corey M

0

Expert Reply:

I was able to confirm with my contact at Optronics that the mounting post on the # MCL95AB is stainless steel, but the mounting hardware is not.

expert reply by: Erik B

0

Answer 1

The majority of brake line installations we do in our shop match the first method you have in the photo, labeled "Branch". We also prefer to use rubber hoses as they are easier to work with and there won't be an issue if you…

view full answer...

Answer 2

There are a couple of ways to mount the Kodiak Tee Fitting for Hydraulic Brake Hose - Brass - 3/16" Female Inverted Flares #BH-T-3FIF. Many will use brake line mounting hardware on either side of the brake line which will provide enough…

view full answer...

Answer 3

The 18.5x8.5-8 is actually an old tire size that is not used much anymore. The closest metric size to your existing tire would be 215/60-8. Your wheel most likely has a 5-on 4-1/4 inch bolt pattern (see link), you will want to make sure that the bolt…

view full answer...

Answer 4

The 1-7/8 inch width is what is rounded up to 2 inches which is a standard width for winch straps. The 14 foot length is not something we carry. I recommend the Hand Winch Strap with Safety Hook, 2" Wide x 15' Long - 4,000 lbs #DL24239 or…

view full answer...

Answer 5

Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…

view full answer...

Answer 6

You will need the Ceiling Garnish for Fan-Tastic Vents Roof Vent #FVK1060-81 as it is specific to your Dometic Fantastic Fan 1450. The Ceiling Garnish for Ventline Roof Vent #VA0445-37 is going to have rounded corners as opposed to the square on the…

view full answer...

Answer 7

The #37213635 JR Products Replacement Landing Gear Switch you'd mentioned would be a proper replacement for your existing Atwood 70254 landing gear switch. If you wanted the switch, wiring harness and the bezel for the switch, use the Stromberg…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

There is a hitch receiver that could work for your 1995 Chevy G20 van, so long as your van does NOT have a step bumper. If so, I recommend the Draw-Tite #75121 hitch, this is a 2" hitch that is a complete bolt-on installation so there will be no…

view full answer...

What is the Post on the Optronics LED Clearance or Side Marker Light Made From

Product Page this Question was Asked From

Continue Researching