What Size Battery Bank for a 2000 Watt Invertor

Question

Question:

I have a 12 v 35 am battery. How many to power a 2000 watt inverter?

asked by: Bob

0

Expert Reply:

If I understand correctly, you have a 12 Volt battery rated at 35 amp hours and want to connect this to a Go Power Industrial Pure Sine Wave Inverter, # 34278156 rated for 2,000 Watt. If you want to operate anything for an extended period of time that needs that large of an inverter then you would need at least 400 AH minimum in your battery bank. So no less than 12. However, trying to wire that many batteries together will cause use of a lot of wire that increases resistance, so be aware of that.

expert reply by: Michael R

0

Answer 1

Typically two batteries are needed for a 2,000 watt inverter like the part #34278156 that you referenced.

view full answer...

Answer 2

An RV air conditioner system is going to pull roughly 100 amps per hour so you wouldn't be able to run it long enough with your current battery bank. RV solar unfortunately isn't at a point where it would replenish the battery bank…

view full answer...

Answer 3

Yes, you can wire your batteries in parallel and then run them to the Go Power Industrial Pure Sine Wave Inverter - GFCI - 2,000 Watt - 12V #34278156. This will keep the voltage the same but double your amp hours. This is a very common practice with…

view full answer...

Answer 4

There is an internal fuse in the Go Power Transfer Switch part #342GPTS but it is included and you would not need to supply it. Usually 6 gauge wire is used for the wiring from the switch to the charger.

view full answer...

Answer 5

I looked up pictures of the front of your 2018 NuCamp Tag Boondock Edition and it uses a standard A-frame style coupler like what the Lock N Roll Articulating Coupler #336TS504 is designed to fit so this would work well for you. You'd have to…

view full answer...

Answer 6

The Go Power Industrial Pure Sine Wave Inverter, #34278156 that you linked to, is rated for 2,000 Watt. To operate anything for an extended period requiring this size inverter, I suggest at least a battery bank of at least 400 AH minimum. The…

view full answer...

Answer 7

For the Go Power Industrial Pure Sine Wave Inverter, #34278156, maxing out or coming close to doing so, you are pulling 2000 watts /12 volts = 167 amps per hour. So if you use a 400 amp battery bank at 12 volts, you would divide 400 amp battery / 167…

view full answer...

Answer 8

You can manually turn off power from your inverter before switching on your shore power, but most people find this tedious and you'll have a delay in power while you switch over. With an automatic transfer switch like the Go Power #342GPTS all…

view full answer...

Answer 9

The Lock N Roll Articulating Coupler #336TS504 dimensions for the A-frame are 2.19" at the narrowest part and 11.22" at the widest part of the opening. It is 9.68" long from largest opening to narrowest. I have included a picture below…

view full answer...

Answer 10

The #C17063 Curt MV Weight Distribution System w/ Friction Sway Control is not compatible with your DO35 hitch. Unfortunately we do not carry one that is. From what I found after reviewing the DO35 hitch, you will need to get the adapter made for the…

view full answer...

Answer 11

The Lock N Roll Articulating Coupler #336TS504 is listed as a weld-on application because it doesn't have bolt holes and was left unfinished to make the welding job easier. If you were willing to drill holes in the coupler you certainly could…

view full answer...

Answer 12

I can definitely help you determine the correct inverter for your TV and coffee machine. To figure out the correct inverter, you simply need to know the amount of watts your TV and coffee machine use. While TVs don't generally consume much…

view full answer...

What Size Battery Bank for a 2000 Watt Invertor

Product Page this Question was Asked From

Continue Researching