Replacing Brake Light Bulbs On 2004 Acura MDX With Putco Plasma LED Lights
Question:
2004 Acura MDX if i install your led stop light bulbs, will the brake lamp indicator on my dash stay off, and do your bulbs have built in resistors needed to keep that brake lamp warning light off on the dash
asked by: James Y
Expert Reply:
If your current brake bulbs are halogen, you will need to add resistors to prevent hyper flashing when you install the Putco Plasma 7443 LED Lights - 360 Degree - Red - 2 Pack, part # P247443R-360. If you are replacing LED brake bulbs you should not need to add resistors to the replacement bulbs. Ideally, in both scenarios, your brake lamp indicator warning light should turn off on your dashboard. In case you do need a resistor I recommend, Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2, part # DI34ZR. You would add one to each of your brake lights and that will eliminate the hyper flashing of your LEDs.
I have included a product description links, video review links, and instructions on how to install the resistors below.
Products Referenced in This Question
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Putco Plasma 7443 LED Lights - 360 Degree - Red - 2 Pack
- Vehicle Lights
- Tail Light
- Brake Light
- Pair of Lights
- LED Light
- Replacement Bulb
- 7443
- Red
- Putco
more information >
Continue Researching
- Q&A: Recommended 6 Inch Oval LED Backup Light For Brightness
- Article: Performance Chips and Modules
- Article: Stability Control for Heavy Duty Vehicles
- Article: Rooftop Cargo Carriers
- Q&A: What is the Difference Between Optronics Lights STL22RB and STL70RB