2" Class III Trailer Hitch Receiver and 4-Way Wiring Harness For a 2020 Ford Escape
Question:
All of the other hitches for my 2020 Ford Escape say you have to lower the exhaust. Do I need to for this model hitch? C23FR Also, it says I might need to drill or use a file on some of the holes? Is that involved? THanks,
asked by: Irv S
Expert Reply:
The Curt Trailer Hitch Receiver # C23FR will require you to temporarily lower the exhaust so that you will be able to access the area where the receiver will be installed. You are only lowering the exhaust to make enough room to insert the receiver and access the fasteners. After you are completed with the installation the exhaust will go right back into the same place it was.
The hole size most likely will need to be enlarged so that the bolts and spacers can be inserted into the frame. We had to do this on the 2020 Ford Escape that I have linked the video below for you to reference.
I recommend installing the Tekonsha T-One Vehicle Wiring Harness # TE54FR at the same time as you will be able to route the wiring and secure it to the receiver easier when you are installing the receiver. The Mounting Brackets # 18136 and # 18144 will provide you with a secure mounting location that requires no drilling.
Products Referenced in This Question
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 4 Round
- 5 Round
- 6 Round
- Tow Ready
more information >
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Q&A: Availability of 7-1/2-inch-long V-Shaped Replacement Keel Roller for Boat Trailer
- Q&A: Wiring Diagram for 7-Way Round Pin Trailer and Vehicle Side Connectors
- Q&A: Converting From 7-Way Round to 7-Way Flat Connector
- Q&A: Solution for Atwood Surge Brake Coupler Needing Replacement Parts
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: 2023 Holiday Must Haves
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Q&A: Needing a Jack to Mount to a 5 Inch Tall Frame Rail
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Choose the Right Trailer Hitch Class
- Article: Pintle-Hitches
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Accurately Measure Trailer Leaf Springs