3 inch RV Sink Strainer Availability

Question

Question:

Hello, What is the diameter of this item? The specs say 3, while the description mentions 3 1/2 I lost one of my plastic strainer baskets for the kitchen sink in my 2016 Forest River Wildwood 23RBS and have been hunting for a replacement. I believe this is the correct part based on the 3inch diameter, so seeing it say 3 1/2 in the item details concerned me.

asked by: Corey L

0

Expert Reply:

Since you need a 3 inch diameter strainer the correct part number you need is the # 34465JNBSK10081 that you referenced.

expert reply by: Jameson C

0

Answer 1

I went out to our warehouse and measured the rubber grommet piece on the Replacement Strainer Basket for LaSalle Bristol RV Kitchen Sink Drains #34465JNBSK10081 and measured a diameter of 1.8" (4.57 cm). Attached is a diagram showing this…

view full answer...

Answer 2

I'd be happy to help you figure out if the replacement strainer #34465JNBSK10081 will fit in the sink of your 2014 Keystone Cougar, but there's no database for what sink was used. The #34465JNBSK10081 measures 3" in diameter, so as long…

view full answer...

Answer 3

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 8

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 9

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 10

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

3 inch RV Sink Strainer Availability

Product Page this Question was Asked From

Continue Researching