Can Dexter E-Z Flex Equalizer Work With Angled Center Hanger W/O Interference?
Question:
My Toy hauler hangers have two sets of holes upper and lower and one side of the hanger is angled. The two end hangers are no problem and have plenty of clearance, but my question is with the center hanger. Can I use this Dexter E-Z Flex Suspension Kit on the upper holes per the pictures I included? I am not sure how much articulation happens with these type of suspensions. I am wondering if the shackle will hit the center hanger on the angled side as it moves. And if the equalizer can go up inside the bracket - how wide is it? The hangers are 1 3/4 wide on the inside.
asked by: JP
Expert Reply:
The Dexter E-Z Flex Equalizers # K71-652-00 you were looking at are right at 1-3/4" wide, but based on the picture you provided you will more than likely not be able to use them in the upper hole of your center hanger as the shackles will likely contact the angled section of the hanger as the suspension moves.
You can use the lower hole as you currently are using, or you can remove the center hanger and have the Front/Center/Rear Hanger for Double-Eye Springs - 3-1/4" Tall - 9/16" Bolt Hole # 28-5 welded in its place which will be very close to the same as the measurement of the upper hole on your current bracket.
I included videos for both of the products mentioned for you to take a look at.
Products Referenced in This Question
Front/Center/Rear Hanger for Double-Eye Springs - 3-1/4" Tall - 9/16" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 9/16 Inch Diameter
- 3-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- etrailer
more information >
Product Page this Question was Asked From
Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 6,000 lbs
- Trailer Suspension Parts
- Equalizer Upgrade Kit
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 5-5/8 Inch Long
- Tandem Axle
- Dexter
more information >
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Can Hydraulic Brakes of Demco Tow Dolly be Converted to Electric Brakes
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Q&A: Torque Specs for 3500-lb 5-on-4-1/2 Dexter Hub/Drum 84546UC3
- Q&A: Installation Information for the Replacement Cables for Enclosed Trailer Ramp Spring # ERS160D96
- Q&A: Wheel and Tire Recommendation For Jet Ski Trailer with Tire Size ST175/80R13
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Harvest Hosts
- Article: What To Look For When Buying Ratchet Straps
- Article: Where to Position the Trailer Axle?
- Article: Must Have RV Accessories that Will Make or Break Your Trip