Jensen JWM60A RV Stereo Removal

Question

Question:

What does it take to remove the Drive stereo. Is it screwed in or is there release somewhere?

asked by: Rod B

0

Expert Reply:

There are screws holding the radio unit in place but they are under the trim piece, that needs to be released first. Please see the attached video showing this at about the 8 minute mark.

expert reply by: Michael R

0

Answer 1

If your Jensen RV Stereo #JWM60A will not turn on, it's going to be either because it's not getting power, it's not grounded properly, or the fuse is blown. Since you already tried resetting the unit, we'll start by checking the 10…

view full answer...

Answer 2

From what I could find on your Jensen AWM975, the main harness should have terminals. I have included a couple pictures outlining the wiring/pin locations. You can then use a circuit tester like the Hook Probe Circuit Tester #PTW2993 to test. You can…

view full answer...

Answer 3

Is it possible the power switch is off? Maybe try pressing the power button for a few seconds. If not try unplugging it for a few seconds so that it resets and then plug it back it in.

view full answer...

Answer 4

The Jensen RV Stereo AWN970 is what is considered as a double din which refers to the cutout dimensions needed for installation. Therefore, if you replace this unit with another double din stereo like the iRV RV Stereo part #IRV34 then the cutout…

view full answer...

Answer 5

The Jensen RV stereo #JWM60A that you referenced has a multi-pin connector for the various power and speaker connections. In the instructions, which I linked for you, the wiring diagram shows +12V power should connect to the RED wire for pin 15; the…

view full answer...

Answer 6

There are 8 speaker outputs on the Jensen #JWM60A, so you can connect 1 speaker per output. According to Jensen, you shouldn’t have trouble hearing the audio when watching a movie, you'll want to set your TV to fixed volume, or simply turn the TV…

view full answer...

Answer 7

There is a trim piece that goes around the sides of the face plate of the Jensen Stereo #JWM60A that you referenced. With it removed you'd have access to the mounting hardware for the stereo. In the attached picture you can see the plates removed…

view full answer...

Answer 8

To replace your RV's Jensen AWM960 stereo/DVD unit I suggest the item you looked at, the Jensen 3-zone AM/FM-CD/DVD-USB-Bluetooth Stereo head unit #JWM60A which shares the same general design and capabilities. A photo with dimensions is included…

view full answer...

Answer 9

The Jensen RV Stereo #JWM60A that you referenced does not have an HDMI cable for connecting to a TV. It instead uses RCA cables which are present on the back of the unit. This is how you'd have to connect to your TV. If you only have an HDMI…

view full answer...

Answer 10

The JWM62A actually replaced the #JWM60A and we decided to keep the old part number on our site. So if you ordered a #DV1230BL you'd actually get the current updated version JWM62A.

view full answer...

Answer 11

To perform a hard reset on your Jensen Stereo like the Double DIN #JWM60A you will just need to locate the small recessed hole/button on the front of the unit (see picture for example). Use the tip of a ball point pen or similar object like a…

view full answer...

Answer 12

I have attached the wiring diagram of the Jensen RV Stereo part #JWM60A for you. This is what you will need to replace the Jensen RV Stereo AWM970 that you have now. The plug that came on the AWM970 will need to be cut off and then the one from the…

view full answer...

Jensen JWM60A RV Stereo Removal

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching