What Kind Of Screw Driver Is Required To Remove Cover On Lippert Electric Jack LC285318?
Question:
What kind of screw driver should I use to remove the 4 screws in my electric Jack???
asked by: Lisa
0
Expert Reply:
You will need a Philips head screw driver to remove the screws holding the top cover of your Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black # LC285318 on, but there are actually 4 screws. 2 in the front, 2 in the back, and 2 underneath the cap on the top of the jack.
I included a video of the # LC285318 for you to take a look at.
expert reply by:
Samuel C
0
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Article: Trailer Wiring Diagrams
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: What Kayak Carriers Will Fit The Thule TracRac TracONE Crossbars
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Most Popular Wheel Bearings
- Article: Best Camper Jacks
- Article: RV Pre-Departure Checklist
- Article: Trailer Jacks
- Article: How (and Where) to Connect an RV Propane Grill