Recommended Flat Towing Spare Tire Carrier for Dually Wheels

Question

Question:

It is possible to mount 16inch dually by reversing tire and using a stack of washers and longer bolts. Do you see any issues with this?

asked by: Robert W

0

Expert Reply:

Roadmaster doesn't recommend altering the # RM-195125 spare tire carrier by reversing the wheel and using longer bolts and washers that would move the wheel further out from the carrier.

Moving the load further rearward would reduce the tongue weight capacity of the carrier to an unknown degree, which could possibly damage the carrier. Instead, they recommend using the # RM-195225 carrier which has a higher, 400 lb tongue weight rating and is compatible with all wheel bolt patterns.

expert reply by: Mike L

0

Answer 1

The difference between the #RM-195125 and the #RM-195225 is that they are designed for different sized wheels; the #RM-195125 is designed to handle up to 16.5" tall wheels where the #RM-195225 can hold between 16" and 24.5" tall…

view full answer...

Answer 2

There seemed to be a few discrepancies with the measurement you requested, so I decided to go pull a Roadmaster Spare Tire Carrier #RM-195125 out of the box and check for myself. With that said, I did get completely different measurements. I included…

view full answer...

Answer 3

The Roadmaster Spare Tire Carrier #RM-195125 that you referenced most likely will still work as it can tilt down to the side so that the spare would get out of the way of the rear slide out. See attached picture.

view full answer...

Answer 4

The Roadmaster Spare Tire Carrier #RM-195125 would be adequate to be used when flat towing your 2019 Jeep Wrangler as it has enough towing capacity at 6,000 lbs.

view full answer...

Answer 5

Basically the two carriers are pretty similar but the part #RM-195225 is designed for larger and heavier wheels as it has a capacity of up to 400 lbs and has a larger mounting flange whereas the #RM-195125 has a capacity of 200 lbs and a smaller…

view full answer...

Answer 6

We aren't a manufacturer, but we do carry a spare tire carrier from Roadmaster that sounds exactly like what you're looking for. The #RM-195225 sounds like it would do the trick for you. The carrier will tilt to the side, making loading and…

view full answer...

Answer 7

I checked with Roadmaster and they told me that from the center of the hitch pin to the other end of the hitch opening measures 14.88 inches.

view full answer...

Answer 8

The Roadmaster Spare Tire Carrier #RM-195125 holds virtually all wheels with a lug nut circle up to 8". The wheel diameter does not matter. The tire diameter and sidewall also do not matter. The only possible exception is deep dish or…

view full answer...

Answer 9

The Roadmaster spare carrier part #RM-195125 was actually designed with the Sprinter in mind so it would work great for what you are looking for and would allow the rear doors to open when the rack was swung down.

view full answer...

Answer 10

The difference between the item #RM-195125 and the item #RM-195225 is that they are designed for different sized wheels. The item #RM-195125 is designed to handle up to 16.5" tall wheels where as the item #RM-195225 can hold between 16" and…

view full answer...

Answer 11

The standoff on the Roadmaster Spare Tire Carrier part #RM-195125 is 6-5/8". This is measured from the face of the mounting plate to the front of the vertical upright. If you need more clearance then you could likely place some spacers in…

view full answer...

Answer 12

I recommend the Roadmaster Spare Tire Carrier #RM-195125 for your 2023 Winnebago Travato 59KL. I have included a picture with this carrier on a Travato so you can see how it will fit past the bumper and ladder. If you are wanting to use the…

view full answer...

Recommended Flat Towing Spare Tire Carrier for Dually Wheels

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching