Will the Bumper Need to be Modified to Install the Draw-Tite # 75684 on a 2013 Kia Sorento
Question:
What model wouldthe bottom of the bumper have to be notched out? Thanks
asked by: Ron
Expert Reply:
There are no models of the 2013 Kia Sorento that will require you to notch out any portion of the bumper to install this Draw-Tite # 75684. The installation of this 75684 is very straightforward and basically just involves raising the hitch into position and then bolting it in place.
There is a Curt hitch that will require some trimming of the heat shield and trimming of the lower fascia on some models though. This hitch is Curt hitch # C13073.
I have attached installation instructions and install videos for you to compare.
Products Referenced in This Question
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Comparing Curt # 13195 and Draw-Tite # 75908 for 2017 Kia Sorento
- Q&A: How To Determine if a 2011 Kia Sorento has the Factory Towing Prep Package
- Q&A: How to Tell if 2020 Kia Sorento Has Factory Tow Package
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Is Drilling Required to Install Draw-Tite Trailer Hitch on 2012 Hyundai Santa Fe
- Q&A: How to Determine if a 2013 Kia Sorento has a Factory Towing Prep Package
- Q&A: Will Rear Hatch of 2012 Kia Sorento Open With a 24 X 60 Hitch Cargo Carrier Installed and Loaded
- Q&A: Adapter and Re-Wiring Kit for Lance Truck Camper with Round Pin 7-Way Plug
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Hitch Receiver Sizes