Will Thule Premium Key Fit Non-Premium Thule Lock Core

Question

Question:

Are the premium Thule keys compatible with the normal ones? Do you have the premium available for all lock core numbers?

asked by: Jake

0

Expert Reply:

The premium keys and the standard keys with the same key number are the same. So the key number of the # 1500004217 which is N127 would work with the non-premium lock core that is N127.

expert reply by: Jameson C

0

Answer 1

I went out to the warehouse to measure the overall length of Thule Replacement Buckle Strap #753-2030-17. it is approximately 125-1/2 inches long. That is nearly 10-1/2 feet long.

view full answer...

Answer 2

The Thule Vertex 2-Bike Rack part TH9028 would require two total lock cores for security which come with the Cable Lock part #TH538XT and Hitch Lock part #THSTL2. If you want to replace both with the same key then you'd need the Thule One-Key…

view full answer...

Answer 3

We do have a Draw-Tite Hitch that fits your 2018 Subaru Outback but #75082 isn't the right one. It fits previous generations of the Ford Ranger and Mazda trucks. The hitch you need is #75673. I included an image to show you what it will look like…

view full answer...

Answer 4

I have an answer for you. From the looks of your photo, it looks like it is the Rapid Gutter Feet for Thule Crossbars - Rain Gutters TH300R. However, even though the knobs on the Rapid Gutter Feet involve a space for Thule Same-Key Lock Cores…

view full answer...

Answer 5

For your Thule EasyFold XT Bike Rack for 2 Electric Bikes #TH903202, you can use the Replacement Lock Cylinder and Premium Key for Thule One-Key Systems #1500004217 with the Replacement Locking Knob for Thule Bike Racks #TH79JV. You'll also need…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Will Thule Premium Key Fit Non-Premium Thule Lock Core

Product Page this Question was Asked From

Continue Researching