Electric Jack for 2017 Winnebago Micro Minnie 2106 fbs Plus Wiring Products
Question:
I have a 2017 Winnebago Micro Minnie 2106 fbs. I am looking for a recommendation on an electric jack I use a weight distribution system and an easy to load A-frame 2 bike carrier. Thx!
asked by: Ronald K
Expert Reply:
A quick and easy jack upgrade can be done with the etrailer # EJ-3520-BBX Electric Jack with foot plate.
You can further upgrade by selecting the Lippert # LC643589 Smart Jack. Hitch memory automatically returns your trailer to the position at which you unhooked. Up/down buttons allow easy one-touch operation. Check out the attached videos to see the extra features.
Both of these jacks install where you old one is right behind the coupler and will not interfere with your weight distribution system or bike rack.
Either way you will just bolt on and connect the old wires to the new wires. I recommend using our Deka # DW05745-5 heat shrink butt connectors once they are crimped. If you don't already have a good crimp tool add the Performance Tool # PTW30764 crimping pliers to your order.
For a nice clean and tight installation us the Deka # DW05726-25 cable ties to guide the wires down the jack tube.
If you additionally need a trailer A-frame bike rack I would recommend the Swagman # S80503 Stratler Rack Carrier. You can then use any typical bike rack that you might use in a 2” hitch receiver on the back of your vehicle, like the Thule # TH9058 2-bike rack. You must use a hitch anti-rattle clamps # RSCP on the hitch where the bike rack attaches. The bikes catch a lot of wind in this location and without the clamp they will wiggle more. Finally, remember that with these A-Frame racks, the weight limit for the hitch and bikes must be under 100 pounds.
Depending on your vehicle we may have a front hitch available like the Draw-Tite # 65005 Front Mount Trailer Hitch. Just let me know your vehicle details and I can tell you what is available.
Products Referenced in This Question
Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- Draw-Tite
more information >
Deka Cable Ties Kit - UV-Resistant - Black - 50 lb Tensile Strength - 11" Long - Qty 25
- Electrical Tools
- Cable Management
- Cable Ties
- 11 Inch Long
- Black
- Deka
more information >
Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Deka
more information >
Lippert Smart Jack Electric Trailer Jack w/ Footplate - A-Frame - 22-1/2" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22-1/2 Inch Lift
- Bolt-On
- 1 Jack
- Lippert
more information >
Performance Tool Crimping Pliers - 10 to 22 AWG Wire - 9-1/2" Long
- Electrical Tools
- Wiring Tools
- Wire Crimper
- Red
- Performance Tool
more information >
Brophy Stabilizer Clamp and U-Bolt for 2" Hitch Receiver - Black Powder Coated Steel
- Hitch Anti-Rattle
- Standard Anti-Rattle
- Universal
- Fits 2 Inch Hitch
- Clamp Style
- Accessory Anti-Rattle
- Brophy
more information >
Swagman Straddler Trailer-Mounted Bike Rack Carrier for A-Frame Trailers - 2" - 100 lbs
- RV and Camper Bike Racks
- Hanging Rack
- Platform Rack
- Tongue Mount Hitch Rack
- 2 Bikes
- Electric Bikes
- Fat Bikes
- Mountain Bikes
- Travel Trailer
- Swagman
more information >
Product Page this Question was Asked From
Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- 1 Jack
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Best Camper Jacks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Article: Trailer Wiring Diagrams
- Article: Determining Trailer Tongue Weight
- Q&A: Replacement Margay Wheel in Gunmetal Gray for ALCOM Stealth Car Hauler
- Q&A: Electric Trailer Jack Recommendation for a 7,500 lb Boat Trailer
- Q&A: Venture Bevel Gear Kit Instructions
- Q&A: What Size Tires Fit 15x6 Inch Steel Trailer Wheels
- Q&A: All Parts Needed to Flat Tow 2023 Cadillac Escalade With Blue Ox Tow Bar
- Q&A: Can the MORyde Safe-T-Rail be Installed On a Class A Motorhome
on Trailer Jack
