LED Red Marker Lights That are Made in the USA
Question:
Hello, Looking for LED side marker trailer lights that are red and made in the USA. Is there such and item? Thank you
asked by: Jason
Expert Reply:
We do have some red LED clearance lights that are made in the USA. They are made by Command Electronics, and I was able to confirm with the manufacturer that the following lights are in fact made in the USA:
- LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Red Lens # 328-K-59LB
- Hot Dot LED Trailer Clearance and Side Marker Light - 2 Diodes - Red Lens # 328-003-17R
Both of these lights are surface mounted and have 2-wire leads, with the red wire being the power wire and the white wire being the ground wire. The difference between the two is in their dimensions, with the Hot Dot LED light being 2-3/4" long with mounting holes 2" apart on center, and the other LED being 3-7/8" long with mounting holes 3" apart on center.
To install them you can use Butt Connectors # 05731-5, and I've added links below to video reviews as well as an install for you to check out.
Products Referenced in This Question
Hot Dot LED Trailer Clearance and Side Marker Light - 2 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 2-3/4L x 1-1/8W Inch
- Red
- Command Electronics
more information >
LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 3-7/8L x 1-7/8W Inch
- Red
- Command Electronics
more information >
Product Page this Question was Asked From
16-14 Gauge Butt Connector - 5 Pack
- Wiring
- Wire Connectors
- Butt Connectors
- 16-14 Gauge
- Deka
more information >
Continue Researching
- Shop: LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Red Lens
- Shop: LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Black Base - Red Lens
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Are Breakaway Switch Wires Interchangeable
- Q&A: Replacement Cable and Pin for Bright Way Breakaway Switch on Trailer 2348
- Q&A: Troubleshooting Hub and Spindle Not Fitting Together after Replacing Spindle on a Utility Trailer
- Q&A: Troubleshooting Trailer Connection Getting HOT
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Right Replacement Hubs for a Trailer with 3500 Pound Axle and 5 on 4-1/2 Bolt Pattern
- Q&A: Trailer Tire Recommendation for Sundowner 20’ Gooseneck with LT235/85R16
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Article: Testing Breakaway Systems
- Article: Using a Portable Generator on RV
- Article: Brake Controller Installation: Starting from Scratch