Installation of Replacement Power Gear Manual Leveling Control Kit

Question

Question:

Will the new panel wires plug up the same

asked by: Edwin T

0

Expert Reply:

Yes, when using the Replacement Lippert Components Power Gear Manual Leveling Control Kit # LC359259 you will want to match the new wires with the same connections as the old panel, since the functions will be the same.

expert reply by: Erik B

0

Answer 1

I reached out to my contact at Lippert and he said that both the Keypad 500456 and the 500457 module are obsolete but the Replacement Components Kit #LC359259 will work perfectly to replace both components. This will get your system back up and…

view full answer...

Answer 2

I'm not sure how old your Lippert Power Gear Manual Leveling System is but the module and keypad design has indeed been upgraded since the original release. The original harness/keypad are no longer made but the Replacement Control Kit #LC359259…

view full answer...

Answer 3

I reached out to my contact at Lippert and he said that it sounds like you have an older Power Gear Manual Leveling kit that had the ground running from the solenoid to the control board. This new kit, part #LC359259, can be used as a replacement but…

view full answer...

Answer 4

The plug that includes the red wire from the Replacement Lippert Power Gear Manual Leveling Control Kit #LC359259 will plug into the back of the control panel and then the other end will plug into the connector coming off of the pump. The other…

view full answer...

Answer 5

Since it is an exact replacement for your original you can just plug in the new Lippert Power Gear Control Panel #LC359259 to your existing wiring harness. Lippert leveling system controls like this are plug-and-play, meaning the new unit should…

view full answer...

Answer 6

What you have is an older design, but we have checked with Lippert in the past and they have told us that the #LC359259 does work as a replacement for the module you have now and will upgrade it to the current design.

view full answer...

Answer 7

According to Lippert, all of the parts in the kit should be used. There are, however, some wiring changes that have been made at the pump assembly for the system to operate. The 6-pin wiring harness that you are referencing plugs into the back of the…

view full answer...

Answer 8

To replace your Power Gear controller #500457 you will need the Replacement Lippert Power Gear Manual Leveling Control Kit #LC359259. This will give you a new touchpad controller and the wiring necessary to work with your system.

view full answer...

Answer 9

The touchpad of your Power Gear setup is in need of replacing and the part #LC359259 would be the correct replacement for that.

view full answer...

Answer 10

I do have a solution for you, but since the Power Gear 500457 and 500456 are obsolete you will need to replace the controller and keypad. To do this you'll need the Replacement Lippert Power Gear Manual Leveling Control Kit #LC359259. This will…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Installation of Replacement Power Gear Manual Leveling Control Kit

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching