Trailer Wiring Harness & Hitch for 2017 Ford C-Max

Question

Question:

do you have a wiring kit and hitch for my ford 2017 ford c-max

asked by: Tony

0

Expert Reply:

We have exactly what you're looking for to pair with the EcoHitch # 306-X7200, which is also a confirmed fit on your 2017 Ford C-Max.

To install a 4 way trailer wiring harness on your 2017 C-Max, you need the Tekonsha # 119250KIT.

expert reply by: Erik B

0

Answer 1

I spoke with my contact at Go Power and he said that under good sun conditions and with limited to no power draw, the 10 Watt Solar Panel Charging System #34273836 that you referenced should be enough to provide a sufficient trickle charge to your…

view full answer...

Answer 2

The first thought people tend to jump to is charging an additional battery via the alternator. The problem with this solution is that unless you are only powering smaller accessories like cell phones the alternator won't be able to sufficiently…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Trailer Wiring Harness & Hitch for 2017 Ford C-Max

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching