Propane Tee Options To Provide More Connection Points for Accessories

Question

Question:

Can an additional T be purchased separate? I need 2 of the T fittings in total but only 1 hose.

asked by: Johnathan S

0

Expert Reply:

The Camco 90-Degree Brass Propane Tee w/ 3 Ports and 12' Long Extension Hose # CAM59143 you asked from has the similar Tee as the MB Sturgis Sturgi-Stay T-Fitting # 103612-MBS which you can use as a second tee.

I've also linked the page to all the Tee options we carry to assist if you are looking for something similar yet with more or other connections.

expert reply by: Jason S

0

Answer 1

The MB Sturgis Sturgi-Stay T-Fitting for Type 1 Valve #103613-MBS is the part you are looking for. This will mount between your propane tank valve and regulator on your RV to let you connect to your Coleman stove. I have attached a help article and…

view full answer...

Answer 2

Yes, the Camco 90-Degree Brass Propane Tee w/ 3 Ports and 12' Long Extension Hose #CAM59143 that you referenced is the type of adapter you'd need to run your portable gas grill from your propane tank setup. This will tee into the setup before…

view full answer...

Answer 3

If your Weber Traveler Grille uses a standard 1 lb propane bottle then it has an internal regulator and cannot be plugged into the quick disconnect port on the side of a trailer. Instead, you'll need tap into the propane supply before at the tank…

view full answer...

Answer 4

You will be able to connect your Blackstone to your 2020 Grand Design Imagine Travel Trailer but you won't be able to go directly to the quick disconnect like you want. Since the Blackstone has its own regulator and a proprietary connection and…

view full answer...

Answer 5

Thank you for sending these additional pictures. It appears that the hose with fittings, that you have, are designed to connect directly to a 20 pound propane tank. Therefore, on one end you have a large Type-1 connector to attach direcly to the 20…

view full answer...

Answer 6

It sounds like the part #CAM59143 is the product you would need but you would have to compare the connection styles of this adapter with what you need for your accessories to be certain. Propane tee has 3 ports Type 1 ACME nut lets you connect your…

view full answer...

Answer 7

The Camco 90-Degree Brass Propane Tee #CAM59143 can be attached to dual tanks with the correct adapters/hoses but hooking two tanks directly to this tee would cause them to backflow into each other. You would need to use a regulator like #CAM59005…

view full answer...

Answer 8

The Camco 90 degree elbow fitting #CAM57633 is designed for use with LP gas systems (propane) so I do not see any reason why you can't use it. It should work just fine for you provided it is the right size needed. It has a 3/8" female swivel…

view full answer...

Answer 9

I would recommend using something like the MB Sturgis Propane Elbow Adapter #204163, which is an adapter that will allow you to get the 90 degree angle you are needing. This adapter has the same fittings the hose you were looking at has. I don't…

view full answer...

Answer 10

I reached out to the manufacturer who told me the thread type of the Camco 90 Degree Connector Elbow #CAM57633 is not BSPP it is NPT (National Pipe Thread). It has a 3/8" female swivel flare as well as a 3/8" male flare.

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...