Is Timbren Suspension Enhancement for 2019 Nissan Frontier Compatible With Lifted Truck

Question

Question:

Hello, is this compatible with a lift kit? I drive a 2019 Nissan Frontier 4x4 Crew Cab.

asked by: Dan H

1

Helpful Expert Reply:

You can install the Timbren Rear Suspension Enhancement System # TTORTUN4L on your 2019 Nissan Frontier with a suspension lift.

In order to do so, you need to add the appropriate amount of spacers that will allow you to wind up with between 1/2" and 1-1/2" of space between the spring and its contact point above the axle. The spring itself measures 3-3/4" tall so you can use that as a guideline to determine how many of the following spacers you will need:

- Timbren 1" Spacer # A25723-90AH00

- Timbren 1/2" Spacer # TA25722-90P00

I have added a link to a video review for you to check out as well of the Timbren Rear Suspension Enhancement System # TTORTUN4L.

expert reply by: Kyle S

1

Answer 1

The SumoSprings Solo Custom Helper Springs #SS98DR, which fit a 2014 - 2021 Nissan Frontier, will fit as long as the lift is a body lift and it doesn't actually lift the frame of your vehicle. If it does lift the frame then I recommend…

view full answer...

Answer 2

Thanks for the helpful information! For your 2018 Nissan Frontier there are two really nice rear suspension-enhancement systems that I recommend looking into. They are the Firestone Ride Rite Air Bags - Rear Axle #F2558 and the Timbren Active…

view full answer...

Answer 3

The Timbren kits like the #TTORTUN4L that you referenced do not raise the suspension of the vehicles they install on. They only reduce sag when the vehicle has weight on it from either a trailer tongue or cargo. There will be about 1.5 inches of…

view full answer...

Answer 4

We have Timbren suspension enhancement kits that fit your 2019 Nissan Frontier 4x4 with the part #TTORTUN4L but we do not have any SumoSpring kits that fit your vehicle. This kit will give you an additional 3,000 lbs of suspension support.

view full answer...

Answer 5

The lip is supposed to be there. It appears to be a way to allow the bracket to set more level than what the frame of the truck allows since it is angled and not parallel to the ground.

view full answer...

Answer 6

Just like the SumoSprings Solo Custom Helper Springs #SSR-612-47, the Timbren Rear Suspension Enhancement System #TTORTUN4L will also replace the factory bump stops and mount directly over the axle, there is no offset. As far as actual lift goes,…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 11

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Is Timbren Suspension Enhancement for 2019 Nissan Frontier Compatible With Lifted Truck

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching