Replacement Gearbox for Venture Landing Gear

Question

Question:

Hi, I ha a venture VMC940RB-356486 gear box that is worn out. What is the replacement part?

asked by: Jean P

0

Expert Reply:

For your Venture landing gear with a worn out gear box, what you need is the Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies # LC276602.

I have added a link to a video review as well.

expert reply by: Kyle S

0

Answer 1

It sounds like you need a replacement gearbox. For a Venture replacment, that is aluminum instead of plastic, part #LC276602 is what you're looking for.

view full answer...

Answer 2

Normally there are 4 of the wear pads like part #LC103480 in the gear pack. To access them the slide rail would need to come out.

view full answer...

Answer 3

The Dexter Heavy Duty Suspension Kit #K71-360-00 is designed for 33 inch axle spacing. To add your third axle, you cannot simply add a hanger spring and axle. You can keep your 35 inch spacing but you will need to relocate your hangers. I've…

view full answer...

Answer 4

We do have motors that you can add to your landing gear. For example, the Landing Gear Set #RVLG-8000 can be operated with the manual crank #RVLG-HDL but you can also add the motor #LC142178 and switch #LG-145236 for effortless operation on your end.…

view full answer...

Answer 5

If the landing gear on your 2018 Dutchman Endurance 3556 toy hauler is branded as a Lippert, Venture, Stromberg, or LCI the Lippert Components HD 6500-lbTuson 5th Wheel RV Landing Gear Motor #LC196308 that you referenced is a confirmed fit as an…

view full answer...

Answer 6

I recommend the heavy-duty 6500-lbTuson motor, part #LC196308 for your landing gear. This motor is easy to install and requires no assembly. The Tuson High Speed 5th Wheel RV Landing Gear Motor, part #LC141893 has a weight capacity of 5,000-lbs.

view full answer...

Answer 7

Any powered landing gear or powered tongue jack will draw less power as it legs descend down toward the ground and much more as soon as they make contact and encounter resistance. This is a normal occurrence. In the same way, any jack - even a manual…

view full answer...

Answer 8

When a trailer jack has to do more work it will draw more power. If it draws excessive power then the fuse will blow. Something is causing the motor to draw excessive power. If the weight of the trailer has not changed then it could be a wiring…

view full answer...

Answer 9

All of the feedback we have received on the Lead Jack Repair Kit part #LG-146059 has said that with the jack removed from the trailer the repair kit installs very easily. I spoke to my contact at Stromberg Carlson and she said there is no reason you…

view full answer...

Answer 10

Fuses blow because the circuit is getting overdrawn. If the motor of your landing gear is fine but you are still blowing fuses that would indicate that either you are overloading the jack and it is drawing too much amperage, or the next likely…

view full answer...

Answer 11

If it a jack isn't able to raise a trailer properly it's generally because it isn't getting enough power or there is hardware problem. I would first check the wiring and make sure there isn't a short. Also, inspect and clean the…

view full answer...

Answer 12

You've done essentially everything that can be done as the normal causes of slow moving landing gear and blowing a fuse are the wiring, a bad motor, a weak battery, or issues with the legs. And the fact the FOB doesn't cause an issue with the…

view full answer...

Replacement Gearbox for Venture Landing Gear

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching