Where is Grease Fitting of Bearing Buddy for Trailer Hub
Question:
Where’s the grease fitting? How does this work?
asked by: William
0
Expert Reply:
If you check out the diagram I attached for Bearing Buddies like the # BB1781 you can see that the grease fitting is beneath the cap. Basically you attach your grease gun to the fitting and then pump in grease until you see the piston move slightly while turning the hub. It's easy to over fill hubs with these so be careful not to go too crazy with it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1781 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.781 Inch
- Bearing Buddy
more information >
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Article: My Trailer Hitch Doesn't Fit
- Video: etrailer Trailer Hitch Installation - 2022 Chevrolet Colorado
- Video: Hopkins Multi-Tow Trailer Connector Installation - 2022 Chevrolet Colorado
- Video: Hopkins Trailer Wiring Harness Installation - 2022 Chevrolet Colorado
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Hopkins Multi-Tow 7-Way Blade and 4-Way Flat Trailer Connector - Chevrolet/GMC
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: c13176
- Video: etrailer Trailer Hitch Installation - 2020 Chevrolet Colorado
- Video: Hopkins Multi-Tow Trailer Connector Installation - 2020 Chevrolet Colorado
- Video: Curt Trailer Hitch Installation - 2022 Chevrolet Colorado
- Q&A: Do I Replace U-Shaped Bracket on Underside of 2020 Chevy Colorado for Hitch Install
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Q&A: Rear Bumper Needs to be Supported When Installing Curt C13176 Trailer Hitch Receiver-2016 GMC Canyon
- Q&A: Does Spare Tire Bracket Get Bolted to Curt Hitch C13176 on 2016 Chevy Colorado
- Shop: 4' Pigtail Wiring Harness for Pollak Replacement 7-Pole RV Socket
- Shop: 7-Pole and 4-Pole Trailer Connector Sockets w/ Mounting Bracket and Wiring - Vehicle End
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Connector
- Q&A: How To Tell If Bearing Buddy Has Enough Grease
- Q&A: How Does a Bearing Buddy Get Installed and Removed
- Q&A: Is It Normal For Grease To Appear Under Bearing Buddy Bra/Covers?
- Q&A: Troubleshooting Grease Seal Failure when Using Bearing Buddy Bearing Protectors
- Search Results: boat trailer wheel hub kit
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Video: Review of Dexter Trailer Hubs and Drums - Pre-Greased 3500 LB - 84546UC3-EZ
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Search Results: 44649
- Article: How to Choose the Right Trailer Hitch Class