Is Plunger of Replacement Breakaway # 3802348 Available

Question

Question:

can i get just the plunger for this switch? Replacement Breakaway Switch Item # 3802348

asked by: James E

0

Expert Reply:

Just the plunger of the # 3802348 is not available so if you were in need of it you'd need to just go with # 3802348

expert reply by: Jameson C

0

Answer 1

You are correct to a degree. When using the Self-Tapping Screw (Zinc) #FA1131822 to ground to a steel frame, it comes down to what type of steel the frame is constructed of. The Self-Tapping Screw (Zinc) #FA1131822 is ok to be used with galvanized…

view full answer...

Answer 2

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 3

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…

view full answer...

Answer 4

To be completely honest the sway control feature of the B and W Continuum part #BW78FR isn't nearly as advanced as the rest of the system. The advertised sway control of this system is in the head of the system between where the ball and the…

view full answer...

Answer 5

Hi there Ryan; thanks for the question and the easiest weight distribution hitch to connect and disconnect after initial set up is the B&W Continuum, with the right one for your 2-1/2" hitch being the following: - B&W Continuum Weight…

view full answer...

Answer 6

The B&W Continuum Weight Distribution System part #BW78FR requires at least 24" of space on the frame directly behind the coupler and along the side a few inches back from there. This works with most trailers but for some it will not and,…

view full answer...

Answer 7

According to RoadActive Suspension the spring rate for the standard kit #RAS3611-S is 2,400 lbs. For the heavy duty #RAS3611-SHD it is 3,600 lbs. The heavy duty #RAS3611-SLHD is the same but only designed to fit if you have factory top overload…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Is Plunger of Replacement Breakaway # 3802348 Available

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching