Wider Trailer Tire to Replace 4.80-12 on Boat Trailer
Question:
Will the offset on the rim will fit on the trailer without a spacer? Just wondering what the clearance needed from the spindle to the frame is needed?
asked by: Daniel
0
Expert Reply:
For a much wider setup that will have right at the same overall diameter and bolt pattern we have the 205/65-10 tire and wheel combos like part # AM3H460. This will be basically twice as wide as what you have now.
expert reply by:
Jameson C
0
Products Referenced in This Question
Kenda 205/65-10 Bias Trailer Tire with 10" White Wheel - 4 on 4 - Load Range E
- Trailer Tires and Wheels
- Tire with Wheel
- Bias Ply Tire
- Load Range E
- 205/65-10
- 10 Inch
- N - 87 mph
- 4 on 4 Inch
- Steel Wheels - Powder Coat
- Kenda
more information >
Product Page this Question was Asked From
Kenda Loadstar K371 Bias Trailer Tire - 4.80/4.00-8 - Load Range B
- Trailer Tires and Wheels
- Tire Only
- Bias Ply Tire
- Load Range B
- 4.80/4.00-8
- 8 Inch
- Kenda
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Amber Lens for Trailer Light with SAE A P2 DOT 14
- Q&A: Best Replacement for Old 6.00-16 Trailer Tires
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Trailer Tire Sizing
- Article: 2023 Best Gifts for Haulers & Towers
- Q&A: Replacement 4.80-4.00-8 Tire for Log Splitter
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: What is the Difference Between Load Range B and C Trailer Tires
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Measuring a Trailer Tire
Daniel
4/9/2020
Will the offset on the rim will fit on the trailer without a spacer? Just wondering what the clearance needed from the spindle to the frame is needed?