Will THSTL2 Work as a Replacement for Thule #853-5019-02

Question

Question:

We have lost our old hitch bolt Thule #853-5019-02. Will this work as a replacement for it?

asked by: Daniel

1

Helpful Expert Reply:

Yes the Thule Snug Tite Hitch Lock and Anti-Rattle Device part # THSTL2 can be used to replace your old inactive Thule bolt part # 853-5019--02. They share the same thread size and pitch and will be plenty long enough to secure your rack.

expert reply by: Randy B

1

Answer 1

Since the Thule Rak N Lok has been out of production for quite a few years, Thule does not have any specs or information regarding replacement parts. That said, I will do my best to provide some helpful information or parts that may work. Erailer…

view full answer...

Answer 2

There is going to be a way to use what I will call a "vintage" Thule 938 Rak-N-Loc Classic bike rack, though the Replacement 2" Hitch Adapter #853-7489 you referenced is not a confirmed replacement part when I checked with Thule. What…

view full answer...

Answer 3

The Trailway is basically the same as the Hitching Post Pro so for a 2 inch hitch adapter you'd want the part #853-7489 that you referenced. Then for a hitch pin you'd want the part #7520990001.

view full answer...

Answer 4

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 5

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 6

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 7

The Global Link RV Entry Door Locking Latch Kit #295-000019 that you referenced would be the correct fit for your 2010 Keystone Montana as this is a fit for standard RV doors like what your Montana has. I attached a review video link for this latch…

view full answer...

Answer 8

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 9

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 10

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

I believe I have a solution for you, but I think you may need to remeasure your cutout and/or compare the measurements of your current latch with one of ours. Since latches tend to be fairly universal in size when it comes to the RV world the Global…

view full answer...

Will THSTL2 Work as a Replacement for Thule #853-5019-02

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching