Does Harness of Aries ActionTrac Motorized Running Boards Need to be Connected to Battery

Question

Question:

Hello, dear friends i just bought ARIES 3036571 ActionTrac Truck Powered Running Boards For my Jeep Rubicon 2019, i have seen you tube tutorial for ARIES 3036571 ActionTrac Truck Powered Running Boards installation by Mr. Robert C, very nice job, clear and complete covering, thanks a lot, today i am installing ARIES 3036571 boards on my Jeep, so Can i link the boards harness kit direct to my Rubicon auxiliary button instead of car battery and cancelling harness button? If yes, i have 15 amps button and 30 amps button, which one should i use? please, see updated schematic diagram, of it correct in install? Thanks for concern Greeting Fahad Albarhomi

asked by: Fahad A

1

Helpful Expert Reply:

You should connect the harness of thAries ActionTrac Motorized Running Boards with Custom Installation Kit - LED Lights # AA3036571 directly to the battery of your 2019 Jeep Wrangler Unlimited.

We always recommend going by the manufacturer's direct instructions; if you do not follow them properly not only could you cause unforeseen damage but any warranty would be voided. I have added a link to these instructions as well as a link to the video install for you if you want to take another look.

expert reply by: Kyle S

1

click to enlarge

Answer 1

I actually installed a set of these similar on my Ram and it took a buddy and I about 2 and half hours, including a hardware store run. Luckily you won't have to worry about that, because the Aries ActionTrac Motorized Running Boards with Custom…

view full answer...

Answer 2

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 3

The brake light switch wire isn't useable on the 2020 Jeep Wrangler so you will need the Stop Light Switch Kit #RM-751490 in order to get the brake signal for the brake controller to activate the brakes on the trailer.

view full answer...

Answer 4

To determine the correct drop needed the safest way is to first get the trailer and truck on level ground and level the trailer. You'll measure from the ground up to the top of the inside of the trailer hitch receiver tube on the truck and from…

view full answer...

Answer 5

The Roadmaster Stop Light Switch Kit #RM-751490 sits against the front of the brake pedal post so that when the brakes are depressed it releases the button on the switch and completes the circuit, sending out the signal that the brakes are being…

view full answer...

Answer 6

If your 2020 Jeep Wrangler Unlimited Willys edition has a factory plastic or steel bumper then the Blue Ox Base Plate Kit #BX1139 would be a compatible fit for your vehicle. The Blue Ox Tow Bar Wiring Kit #BLU79FR you referenced would also be a fit…

view full answer...

Answer 7

The Curt Echo Under-Dash Trailer Brake Controller part #C27JR as with most any electric trailer brake controller will draw a very small amount of power even when the vehicle is off so it can save all your settings. That said, the power draw is…

view full answer...