How Thick Is the Gen-Y Hitch Aluminum Loading Ramp Set GH-R84
Question:
With the cross plate for traction what is the total thickness or height of the ramp. So to be clear if it lays flat on the ground how thick is the vertical height? Thanks. looks like 2.5 inches but the guy below said 1 1/4? Gen-Y Hitch Aluminum Loading Ramp Set - 84inch Long x 14inch Wide - 6,000 lbs Item # 325-GH-R84
asked by: Bruce V
Expert Reply:
I spoke with Gen-Y about the Gen-Y Hitch Aluminum Loading Ramp Set part # 325-GH-R84 and was informed that they were 2-1/4" thick when measuring from the bottom of the rail to the top traction bar. The representative went out and measured the loading ramps for you just to be sure as well since there seems to be conflicting reports.
Product Page this Question was Asked From
Gen-Y Hitch Aluminum Loading Ramp Set - 7' Long x 14" Wide - 6,000 lbs
- Car Ramps
- Loading Ramps
- Open Trailer
- 14 Inch Wide
- 84 Inch Long
- Car Hauler Ramps
- 6000 lbs
- Gen-Y Hitch
more information >
Continue Researching
- Video: etrailer Camper Jack - Stabilizer Jack - SJ-R208 Review
- Shop: Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs - Qty 1
- Shop: Gen-Y Hitch Aluminum Loading Ramp Set - 7' Long x 14" Wide - 6,000 lbs
- Shop: Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Shop: Fulton Drop-Leg Stabilizer Jack with Mounting Channel - Weld-On - 28" Leg - 13" Bracket -
- Shop: Stabilizer Jacks - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 2
- Shop: Stallion Stabilizer Jacks - 7" Drop Leg Travel - 22-1/4" - Qty 2
- Shop: Ark Drop Down Corner RV Stabilizer Jacks - 24" Long Corner Steadies - Silver - Qty 2
- Video: Ultimate Trailer Jack A-Frame Topwind Jack Review
- Search Results: stablizer jacks
- Search Results: stablizer
- Search Results: swing down jack
- Q&A: Do All A-Frame Trailer Jacks Use the Same Mounting Pattern and Center Hole
- Q&A: Recommended Solution for Tie Downs on Floor of Suretrac Aluminum Trailer
- Q&A: Can Ultimate Trailer Jack 322-RDJ-2K Be Completely Removed From Mounting Bracket?
- Q&A: Does Brophy Swiveling D-Ring Anchors w Backing Plates and Hardware Come with Hex Bolts
- Search Results: gen y hitch
- Search Results: brophy
- Search Results: jack e up
- Search Results: stablizers
- Article: Trailer Wiring Diagrams
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Shop: Trailer Hitch
- Video: Titan Trailer Brakes T2385200 Review
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: etrailer Stabilizer Jack Review
- Shop: Trailer Wiring
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Article: How to Choose the Right Trailer Hitch Class