How to Use Rhino-Rack T-Load System to Transport Kayak on 2016 Chevy Silverado 1500

Question

Question:

Do the roof assemblies in only one or do you have to buy two. I only need one with the hitch system#RTL002

asked by: Ron

0

Expert Reply:

The Rhino-Rack T-Load Hitch Mounted Load Assist and Support Bar # RTL002 that you referenced is designed to be used with an existing roof rack crossbar system or bare roof carrier, which aren't included with the kit.

If you want to go with a more permanent setup to use with the T-Load the best route is with a crossbar system. If your Silverado has the Crew Cab I recommend the Rhino-Rack Vortex Crossbar System that consists of # RRVA150S-2 for the two 59" Vortex Crossbars in Silver or # RRVA150B-2 for Black, # RRRLKVA for the Mounting Legs, and # DK377 for the Custom Fit Kit.

I have attached a sample install video that you can check out as well.

Now if you are just wanting the Rhino-Rack T-Load System for kayaks and you don't really plan on using a roof rack system for other purposes, a much more economical option would just be to add a foam block carrier like the Malone # MPG152. The foam blocks will simply secure to the bare roof on your Silverado to provide support for the front of the kayak. Tie-down straps are also included.

expert reply by: Chris R

0

Ron

11/22/2019

Do the roof assemblies in only one or do you have to buy two. I only need one with the hitch system#RTL002

Reply

Chris R.

11/22/2019

There isn't a single foam block kit available like the Malone Kayak Carrier # MPG152 that includes the necessary tie-down straps, however it can be easily pieced together. You can use part # MPG158 for the single foam block, part # MPG306 for the Bow and Stern Tie-Down Kit, and part # MPG307-15 for the Cam Buckle Load Straps.

Reply

Answer 1

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…

view full answer...

Answer 2

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

For all intents and purposes, yes, the Fulton drop leg stabilizer jack SJL80300 is the same as the square leg jack you asked about: - Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs #SJ-R208 Different manufacturers but otherwise…

view full answer...

Answer 5

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 6

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 7

It sounds like you have an error on the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC675817. There are a lot of different errors that may possibly pop up with the Lippert Ground Control. Can you tell me exactly what the…

view full answer...

Answer 8

To add a hitch to your 2024 Honda Pilot, I recommend the etrailer item #e27KR. This hitch is custom fit and bolts to your Honda with included hardware. I really like the etrailer hitch item #e27KR because it installs behind your rear bumper cover and…

view full answer...

Answer 9

The etrailer Hitch #e98912 comes with four 1/2-13 x 1 1/2 carriage bolts.

view full answer...

Answer 10

Lippert does not recommend using ATF Type F Fluid as it is not compatible with Lippert hydraulic system #LC251910 seals because they will not work properly. The following automatic transmission fluid (ATF) recommendations for use in Lippert…

view full answer...

How to Use Rhino-Rack T-Load System to Transport Kayak on 2016 Chevy Silverado 1500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching