Solution for Needing Replacement Gear Box for Motor/Gear Box # 7828696

Question

Question:

Looking for gear it about 4 feet long , motor is good but gears are fail

asked by: Alex K

0

Expert Reply:

Based on the number you mentioned I do have a solution for you, but the gearbox and motor of what you have/need are not sold separately so you'd have to go with the Replacement 18:1 Tuson Motor for Lippert Through-Frame Slide-outs part # LC125802 that you referenced to replace both.

expert reply by: Jameson C

0

Answer 1

The gearbox and motor do not come separately therefore you will need to purchase them both together as a whole. The correct replacement motor and gearbox for your trailer with a Thompson Motor/Gearbox 7828696 is the Replacement 18:1 Tuson Motor for…

view full answer...

Answer 2

Based on the numbers and RPM you listed on your Dutchman 2007 trailer the correct slide out motor setup you need is the part #LC125802 that is a Tuson High Speed 18:1 9,000 RPM slide out motor.

view full answer...

Answer 3

I spoke with Lippert and found that their replacement for your PowerGear Slide Out Motor 13-1086 is the Replacement Gear Motor Assembly for Lippert Slide-Out #LC386321.

view full answer...

Answer 4

There is a gear in the housing of the Replacement 18:1 Venture Motor and Driveshaft with Right Angle Gear Box #LC117292 right by where you would bore through so you run the risk of it interfering with the operation of the motor. You'd also break…

view full answer...

Answer 5

We have a couple of options for gear packs for LCI through-frame or above-floor slide-outs, depending on a couple factors. If you have a 2-1/2" x 2-1/2" through-frame slide manufactured before October 2013, there is a gear available, the…

view full answer...

Answer 6

The Replacement 18:1 High Speed Motor Assembly for Lippert Components Venture Actuator and Slide-Out part #LC295380 is only offered by Lippert as a complete unit with the motor and gear. The motor is not available separately from Lippert.

view full answer...

Answer 7

Thanks for the info you listed. Based on that the correct replacement motor is the part #LC295380.

view full answer...

Answer 8

I spoke with a Lippert technician and he said you'll need to do a hydraulic cylinder test to ensure you're not losing pressure. You may have a crack in one of the valves in the manifold causing this. In the attached pictures you'll see…

view full answer...

Answer 9

I spoke with my contact at Lippert who agrees that it sounds like your actuator needs replacing. If you have a LCI Through-Frame Slide-Out or a Tuson motor then the 40" Venture RV Slide-Out Actuator #LC145595 that you referenced is compatible.…

view full answer...

Answer 10

I checked with Lippert Components who likely made the RV frame and structural parts in your 2005 Forest River Rockwood Freedom 5th wheel. My contact there indicated that for your slide-out the appropriate replacement gearbox/motor is part #LC125802.

view full answer...

Answer 11

Yes, the Lippert Components 40" Venture RV Slide-Out Actuator #LC125802 that you referenced is the correct actuator for you. Thank you for the picture you submitted.

view full answer...

Answer 12

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Solution for Needing Replacement Gear Box for Motor/Gear Box # 7828696

Product Page this Question was Asked From

Continue Researching