Will There be Ground Clearance Issues With The Draw-Tite Hitch 76209 on 2019 Subaru Impreza Wagon  

When we installed the EcoHitch part # 306-X7350 on a similar Subaru Impreza as your 2017 model we found that the ground clearance was right at 10-3/4 inches.

When we installed the Draw Tite Hitch part #76209 on a 2018 Subaru Impreza Wagon just like yours we found the height from the top of the trailer hitch opening to the ground measured 10 inches. So what you'll need to do is measure from the bottom…

Both the hitches you mentioned have the same ground clearance. The Draw Tite #76209 and the Curt #C13382 both have 15 inches from the top of the hitch opening down to the ground.

When we installed the Draw-Tite Max-Frame Trailer Hitch Receiver part #76209 on a 2019 Subaru Impreza Wagon there was about 10 inches of ground clearance which is pretty standard. I don't see you have any issues with ground clearance with daily…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…