Which Draw Tite Hitch Fits RoadTrek Simplicity SRT Built on 2018 Ram ProMaster 2500 Chassis

Question

Question:

your expert notes for 75882 states that for extended body length the 76050 is recommended. My Roadtrek Simplicity SRT is 19,58. Which hitch is best? I want to use a Stowaway carrier. Drawtite vs Curt?

asked by: Victoria

0

Expert Reply:

I looked up your Roadtrek Simplicity SRT and it would be considered one of the high roof extended versions of the 2018 Ram ProMaster 2500 so the correct hitch would be the # 76050 that you mentioned.

While we don't carry the Stowaway brand of cargo carriers we do have the GearSpace 34 Enclosed Cargo Carrier # HGK819 that is very similar. Check out the review video I attached for more info on it.

expert reply by: Jameson C

0

Answer 1

The Draw Tite hitch part #75882 is a fit for the 2017 Ram ProMaster 2500. This would be the same hitch that would fit a 2016 ProMaster 2500.

view full answer...

Answer 2

Curt 2-inch hitch #C13207 will give you both the highest available hitch tow rating of 7500-lbs and a simple no-drill installation on your ProMaster 3500. This hitch should take only about half as long to install as the Draw-Tite #75882, about a half…

view full answer...

Answer 3

The Curt Trailer Hitch #C13295 is indeed a fit for your 2018 Ram ProMaster 2500.

view full answer...

Answer 4

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 7

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 8

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 9

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 10

In regards to the Correct Track Trailer Alignment and Lift Kit part #RR23QX, the kit provides a lift by essentially extending the hangers. This normally requires cutting off the old hangers and welding on new, taller ones but with this kit you…

view full answer...

Answer 11

The Correct Track Trailer Alignment and Lift Kit - Tandem Axle #RR23QX does come with all of the components needed to lift a tandem axle trailer. The center hangers of a tandem axle setup use different components than the front and rear hangers since…

view full answer...

Answer 12

The Correct Track Trailer Alignment and Lift Kit part #RR23QX offers a 1-1/4" or 2-1/4"lift so if the hitch height height is lower than the vehicle hitch height you can use this kit to bring the trailer level with the vehicle and eliminate…

view full answer...

Which Draw Tite Hitch Fits RoadTrek Simplicity SRT Built on 2018 Ram ProMaster 2500 Chassis

Products Referenced in This Question

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching