Troubleshooting Leaf Spring Fit on Top of the Axle on a Tandem-Axle Trailer
Question:
Tandem-Axle Trailer Hanger Kit for Double-Eye Springs Axel flip for more clearance after done both springs sit different is this normal??
asked by: Clay
Expert Reply:
I assume by flip, you mean you moved the leaf springs to the top of the axle. If this is the case, then all of the springs should sit the same. There are a few things you can check to ensure everything is in place.
If you had to weld on new hangers to the trailer frame, then I would check and make sure they are attached properly. You will also have to weld new spring seats like # TRSS238 on the top of the axles for the leaf springs to sit on. You can also use a conversion kit like the Dexter Trailer Springs Over-Under Kit, # K71-385-00, which will allow you to put the springs on top of the axles.
You should not flip the axle itself, the axles will have a slight upward bend to them and that is to compensate for additional weight on the trailer. I have attached an image of how the trailer suspension system should look after moving the leaf springs on top of the axles.
I have attached an image of what the suspension system should look like below and on top of the axles for you to check out.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Spring Seat for Typical 3,500-lb, Round Trailer Axles with 2-3/8" Diameter
- Trailer Suspension Parts
- Spring Seats
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Round Axle - 2-3/8 Inch
- TruRyde
more information >
Product Page this Question was Asked From
Tandem-Axle Trailer Hanger Kit for Double-Eye Springs - 2-1/2" Front/Rear/Center
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Tandem Axle
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: roof mounted solar kit rv solar panels
- Shop: Dexter Tandem-Axle Trailer Hanger Kit for 3" Slipper Springs - 38" Axle Spacing
- Article: Double-Eye Trailer Suspension System Review
- Search Results: lights
- Search Results: solar controller
- Search Results: radio
- Q&A: Typical Trailer Lug Nut Diameter and Thread Pitch
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Shop: CE Smith Trailer Wheel Lug Nut - Zinc-Plated Steel - 1/2" - Qty 1
- Shop: Americana Trailer Wheel Lug Nut - Chrome Plated - 1/2"-20
- Article: Where to Position the Trailer Axle?
- Q&A: Tandem Axle Hanger Spacing for Double Eye Springs 25-1/2 Inches
- Q&A: Placement of Front and Rear Hangers When Building a Tandem Axle Trailer
- Shop: Dexter Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 38" Axle Spacing
- Shop: Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs
- Shop: Front/Center/Rear Hanger for Double-Eye Springs - 2-3/8" Tall - 9/16" Bolt Hole
- Q&A: How to Determine Hanger Spacing on 5,200 lb Tandem Axle Trailer
- Q&A: How to Determine Axle Spacing on a 5,000 lb Tandem Axle Trailer
- Shop: Trailer Hitch
- Q&A: Determining Correct Shackle Strap Size for Top Brand Tandem Axle Trailer
- Search Results: axle tube
- Video: Dexter Trailer Springs Over-Under Conversion Kit Installation
- Shop: Front Mount Hitch
- Search Results: 15703
- Search Results: leaf spring hanger
- Video: Redline Trailer Suspension - Leaf Spring Suspension - E4139 Review
- Video: Review of etrailer Trailer Leaf Spring Suspension - 6 Leaf Double Eye Spring 7000 lbs Axle - e64SR
- Video: Trailer Hitch Installation - 2003 Chevrolet Silverado - Curt C15703
- Video: Trailer Hitch Installation - 2001 Dodge Ram Pickup - Curt C15300