Inside Width of Front Hanger for Dexter 10,000-lb General Duty Axles

Question

Question:

Hi, im looking for actual measured inside-width of this hanger. Thank you

asked by: Dan N

1

Helpful Expert Reply:

The Front Hanger for Dexter 10,000-lb General Duty Axles # 10GDH-FTRH34 that you referenced has an inner width of 2-1/2 inches which is the spring width it is designed to fit. This is a higher capacity type of spring used on 10,000 lb rated Dexter axles.

expert reply by: Jameson C

1

Answer 1

Aluminum trailer frames or bodies can cause grounding issues so I suggest using a separate ground wire that runs from the rear of the trailer up to the main ground post in the junction box like #38656. You can join the ground wires for the…

view full answer...

Answer 2

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

view full answer...

Answer 3

The best way to determine the height needed is to measure from the top of your trailer frame to the top of the sides of your boat. If the 40" Tall Guide-Ons #CE27626 sit right at or slightly above the sides of your boat then the shorter will…

view full answer...

Answer 4

What I recommend, if the trailer has round axles, is an over-under conversion kit. For 3 inch round axles use #K71-385-00 and for 2-3/8 inch round axles use #K71-384-00. This of course will only work if the leaf springs are mounted to the bottom of…

view full answer...

Answer 5

You will first want to check the fuses on your tow vehicle. Some vehicles could have fuses for operating the turn signals and brake lights of a towing package. You will want to check if they are installed and working properly. The next thing is to…

view full answer...

Answer 6

First, disconnect the trailer from the tow vehicle so you can check the vehicle side connector. Using a circuit tester like part #PTW2993, test the functions of the connector; specifically check the right turn/brake, to make sure the signal is making…

view full answer...

Answer 7

I attached a link to a page that has install instructions for the Correct Track kit part #RR23QX that you referenced. I'd recommend the shackle bolt kit part #MR58ZR as it comes with the correct size bushings, bolts, and shackle straps.

view full answer...

Answer 8

If a gooseneck trailer isn't sitting level you end up putting the trailer suspension in a situation that doesn't allow it to function properly which will then make it perform strangely like you mentioned. The best solution we can offer is a…

view full answer...

Answer 9

Your brake lights and turn signals for each side are on one circuit. The left side turn signal and brake light is generally the yellow wire going into your trailer connector. The first thing to do is check the fuses on your tow vehicle. Next, inspect…

view full answer...

Answer 10

Most trailer wiring that runs to trailer lights is 16 gauge. I would rather people use 14 or 12 unless the lights are LED which draw considerably less. But for most people 16 gauge works just fine for basic trailer lighting. If you are planning on…

view full answer...

Answer 11

view full answer...

Answer 12

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Inside Width of Front Hanger for Dexter 10,000-lb General Duty Axles

Product Page this Question was Asked From

Continue Researching