Installing Redarc Tow Pro Elite in 2020 Jeep Gladiator
Question:
What adapter harness is required for a 2020 Jeep Gladiator?
asked by: Michael C
Expert Reply:
I did some checking and it looks like your 2020 Jeep Gladiator with the tow package has to have the Redarc Tow Pro # RED44FR brake controller hardwired to the 7-way connector at the rear of it.
For a wiring kit to install the brake controller to the 7-way you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.
Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.
Products Referenced in This Question
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Redarc Tow-Pro Elite Brake Controller - Dash Knob - 2 Braking Modes - 1 to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Dash-Mounted Knob
- Hidden
- Up to 3 Axles
- Indicator Lights
- Redarc
more information >
Product Page this Question was Asked From
Redarc Tow-Pro Elite Brake Controller - Dash Knob - 2 Braking Modes - 1 to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Dash-Mounted Knob
- Hidden
- Up to 3 Axles
- Indicator Lights
- Redarc
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Article: Trailer Maintenance Schedule
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: REDARC Tow-Pro Liberty vs Tow-Pro Elite
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Q&A: Can Short Bed Trucks Tow Gooseneck Trailers
- Q&A: AxleTek Brake Assembly Recommendation for 8k Axles with 4 Bolt Mounting Pattern
- Q&A: How To Tell If Bearing Buddy Has Enough Grease