Receiver Height of Curt Class III # 13650 When Installed on 2009 Ford Escape
Question:
I plan on ordering the Curt trailer hitch # 13650 for my 2009 ford escape plus the wiring accessoies, would you know if there is a predetermined hitch height from the ground to the top of the receiver for this set up. Im trying to firure out the correct ball mount and I have the boat trailer coupler height, I would like to be able to order a ball mount with every thing but it has to be right. Thank You
asked by: Michael R
Expert Reply:
Assuming that your Escape uses a stock wheel/tire, the top of the receiver for the Curt # 13650 would be 16 inches above the ground.
Getting the trailer to tow so that it is level is not an exact science. If you can get it within 1-1/2 to 2 inches of level, you are doing just fine. It is better to have the coupler height a bit higher than level than lower.
In addition to the hitch, wiring harness and ball mount, you might also need the following:
Pin and clip, part # PC3
Locking stainless steel hitch pin, part # e98882
1-7/8 inch trailer ball, # 19260
2 inch trailer ball, part # 19247
I have provided links to the install instructions for the hitch and the wiring harness, as well as links to install videos that you might find helpful.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- CURT
more information >
1-7/8" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 1-7/8 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 2000 lbs GTW
- Class III
- Draw-Tite
more information >
2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 7500 lbs GTW
- Class III
- Tow Ready
more information >
etrailer Trailer Hitch Receiver Lock for 2" Hitch - Flush - 2-5/8" Span - Stainless Steel
- Trailer Hitch Lock
- Standard Pin Lock
- Keyed Alike
- Stainless Steel
- Fits 2 Inch Hitch
- Flush Pin
- 2-5/8 Inch Span
- etrailer
more information >
Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-1/4" Span
- Hitch Pins and Clips
- Standard Hitch Pin
- Fits 2 Inch Hitch
- Fits 2-1/2 Inch Hitch
- 5/8 Inch Diameter
- 4 Inch Span
- Draw-Tite
more information >
Product Page this Question was Asked From
Convert-A-Ball Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10,000 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Matte Black
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- Class IV
- Shock Absorbing
- Convert-A-Ball
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Dexter Brake Assembly Recommendations to Replace Part Number 023-357-00
- Q&A: Fifth Wheel Solution for Cab and Chassis Truck
- Q&A: Above vs Below-Bed Hitches and Recommended Hitch for 2018 Ford F-350 with 6.75-Foot Bed
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Can Demco Kar Kaddy X Be Used to Tow 2022 Chevy Spark with Automatic Transmission
- Article: How Much Does a Boat and Trailer Weigh?
- Q&A: Mounting Bolt Pattern For Ultra-Fab Phoenix Electric Trailer Jack with Remote # UF38-944055
- Q&A: Torque Rating for Spindle Nut on Trailer Hubs
- Q&A: Tubing Diameter of Dexter 6K Trailer Axle Kit 7461121-EB
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Steel vs. Aluminum Ball Mounts
- Article: Trailer Lighting Requirements
- Article: Calculating Portable Generator Power Needs