Will the Curt Adjustable Trailer Hitch Receiver C13701 Fit a 2019 Rockwood 5th Wheel Trailer
Question:
my 2019 rockwood ffiftth wheel has an ibeam construction but the bumper is welded to the bottom of ibeam. the brackets on the ordered part number 13703 require me to remove the bumper? wonderering if you have a different bracket? looks like the bracket from the part #13704 would work better!!
asked by: Rob
Expert Reply:
The Curt Adjustable Trailer Hitch Receiver part # C13701 fits frame rails that are between 18" and 51" apart so if that is what you have on your 2019 Rockwood 5th Wheel Trailer then this will work well for you. I took a look at the installation instructions for you and there should not be any removal of the rear bumper needed. The side plates will be used as a template which can then be attached to the frame via bolts after the main body is attached between them.
I have attached these written installation instructions for you as well.
Products Referenced in This Question
Curt Adjustable Trailer Hitch Receiver - 18"-51" Wide - 2" Drop - Class III - 2"
- RV and Camper Hitch
- Frame Mount Hitch
- 18 - 51 Inch Wide Frame
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Weld-On
- CURT
more information >
Product Page this Question was Asked From
Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide
- RV and Camper Hitch
- Frame Mount Hitch
- 22 - 72 Inch Wide Frame
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Weld-On
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: Trailer Wiring Diagrams
- Q&A: Typical Trailer Suspension Hanger Spacing Relative to Leaf Spring Size
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Best Upgrade for Dometic 310 Part-Timer RV Toilet
- Q&A: How To Connect A Dometic 310 RV Toilet To A Supply Line That's Too Far Away
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: How To Activate 12V Trailer Charge Circuit On 2019 Ford Super Duty With Factory 7-Way
- Q&A: Replacement Lift Motor for Fantastic Vent in 2002 Teton 5th-Wheel Trailer
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry
- Article: How to Replace or Install an RV Roof Vent