What Size Oil Filter Needs To Be Used After Installing the Derale Tube-Fin Engine Oil Cooler Kit

Question

Question:

What size filter will fit once this is installed?

asked by: Matthew

0

Expert Reply:

Once the Derale Tube-Fin Engine Oil Cooler Kit part # D15551 is installed, you can use any oil filter with 3/4"-16 threads. For this, we have the Replacement Filter for Derale Remote Transmission Filter Kits part # D13092 or you can use any of the ones in the attached photo.

expert reply by: Conner L

0

click to enlarge

Answer 1

The Derale Tube-Fin Engine Oil Cooler Kit w/ Spin-On Adapter (Multiple Threads) #D15551 is not a vehicle-specific fit. It will work for your 2017 Ram 1500 so long as you have the required space to mount it; the heat exchanger is 16-5/8" wide…

view full answer...

Answer 2

The Westin grille guard part #45-3540 as one example fits from 2010 to 2021 Ram 1500 models.

view full answer...

Answer 3

The Derale Tube-Fin Oil Cooler #D15551 does not use a thermostat. The filter installs inline with the oil lines and a thermostat will block the flow of oil until the specific temperature is reached. Depriving your engine of oil is certainly not…

view full answer...

Answer 4

An engine cooler and a transmission cooler are always good items to have on your vehicle when towing a trailer. Even though you mention the outside temperatures will be cold, the strain that towing a trailer will put on the engine and transmission…

view full answer...

Answer 5

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 9

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 10

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

What Size Oil Filter Needs To Be Used After Installing the Derale Tube-Fin Engine Oil Cooler Kit

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching