Trouble Installing Trailer Hitch Bolts Into Weld Nuts on a 2011 Honda Odyssey  

This is not a normal fit for the Draw-Tite #75270 on your 2008 Honda Odyssey. I reached out to my contact at the manufacturer and they said that is a big hitch and it can get tweaked side to side. If it is that side to side that isn't lining up,…

The Draw-Tite Class III Round Tube Trailer Hitch Receiver, part number 75270, includes all necessary mounting hardware, as well as installation instructions. This hitch utilizes weldnuts, nuts that are welded into the frame at the factory. Before…

The Draw-Tite #36408 Class II hitch you referenced uses 4 M12x1.75 bolts to attach to the nuts welded into the frame. If they are corroded, and spraying them with a spray lubricant like PB Blaster and using a wire brush like one on a battery terminal…

Before we determine that you have the wrong size install bolts you need to make sure that the bolts not fitting isn't due to the weld nuts of your vehicle being dirty/corroded and that is why they won't fit. Typically on vehicles that have…

The weld nuts were probably still dirty, when you were installing the hitch which caused the weld nut to brake off when putting torque on it. If you have not already installed the other bolts, you will want to clean them out with WD-40 and wire brush…

Yes, it sounds like you broke something. Specifically one of the weldnuts that are on the inside of your 2019 Honda Odyssey's frame for the trailer hitch's bolts to thread into. It's annoying but not really a huge problem. Although…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…