bing tracking image
Q & A Icon

Trailer Hitch for Rear of 2013 Keystone Montana  

Question:

Wanting to mout a hitch on my fifth wheel to hold my generator which is apox 297 lbs it had a 1 1/4 one on it but would not hold the weight think i was about 68.5 from indide i beam to inside i beam will this hold the weight and could brackets be drilled to mount iside to inside i beam since i already have holes there instead of mount under do to ground clearance

0

Expert Reply:

The best hitch solution we have would be the Curt part # 13703 as this hitch can fit I-beam trailer frames like you have that are up to 72 inches in width and also has a 350 lb tongue weight capacity.

Curt requires the use of their stabilizer strap part # 18050 when using their hitch to carry a non-supported load like a bike rack. I attached a review video for you to check for the strap as well.

expert reply by:
0
Jameson C

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>

^

Recently Viewed Products

About Us
photos and videos
1,056,204
Original Photos & Videos

Produced to make sure you know what you are getting and you get exactly what you need.

installations
35,570
Installations Completed

To make sure products work and fit the way they are supposed to.

etrailer call center
2,476,511
Phone Calls & Emails Answered

1,125,924 phone calls and 1,350,587 emails to help find the right solution.

etrailer training
400+
Average Hours of Product Training

We get to know our products firsthand so experts can better help you.

etrailer service
78
Years of Quality Customer Service

Assisting our neighbors and customers, face to face at the counter.

etrailer experts
193,357
Pages of Expert Information

Created to make sure you have all the answers to your questions, from real experts.