Portable Camping Mattress for Use Inside 2008 Toyota Prius

Question

Question:

I have an 08 Toyota Prius Touring. I was looking for an air mattress that fits in trunk of the car and lays across the back seats when they are folded down. I do not fit laying across the bench seat but I do fit in the trunk along the the length of the vehicle. I attached a picture for an example.

asked by: Micah

0

Expert Reply:

We have lots of air mattresses that are larger than the AirBedz model # 341033 that you referenced and you can see all of them on the linked page.

These are available in many sizes and designs so you can take measurements of the Prius' interior to find the best fit. If you can fold your front seats forward enough you may even be able to use one of the longer models.

For some examples, Air Bedz part # 341032 measures 66 long x 52 wide x 10 deep; part # 341003 is larger and measures 73 long x 55 wide x 12 deep.

Since many air mattresses will be too big for the interior of a Prius you might consider an RV bunk mattress like # LC358665 which is 74 x 28 x 2-1/2-inches. Since this mattress is reasonably thin and only a bit more than 2-feet wide it will offer a good fit inside the Prius and it will also not need any time or power for inflation.

We have several sizes and colors available and you can see all models on the other linked page. You can choose a 4-inch-thick mattress like # LC380765 or # LC380767 if you want more comfortable sleeping surface.

Please feel free to tell me your maximum preferred size and I will be glad to offer recommendations.

expert reply by: Adam R

0

Answer 1

I have a couple choices for you. The closest we can get to your length and width is 74 by 28 inches. We have The Teddy Bear RV Bunk Bed Mattress - 74" Long x 28" Wide x 4" Tall - Tan #LC380765 and the Teddy Bear RV Bunk Bed Mattress -…

view full answer...

Answer 2

Compressing two inches might be a little too much for it to fit and feel right so for a slightly shorter option we have the #e27FR that is 73 inches instead which would be a more reasonable amount of compression.

view full answer...

Answer 3

The Hullavator Pro #TH898 will work just fine with Yakima round bars and will not require any additional hardware like what you mentioned. The only step that you will skip in the instructions is installing the special angled end cap (page 5) but my…

view full answer...

Answer 4

The Thule Hullavator load-assisted kayak carrier #TH898 will directly mount onto just about any roof rack bar shapes, including round, square, aero, elliptical, most factory crossbars, and most crossbars with top "T-slot" channels. Yakima…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

For a made in the USA aluminum ball mount we only have adjustable units like the Flash Secure 2-Ball Mount #DTSTBM6600-2S which includes stainless steel hitch balls as well. The Fulton #F97CR you found as well as the similar Curt #C74WR and Brophy…

view full answer...

Answer 8

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

view full answer...

Portable Camping Mattress for Use Inside 2008 Toyota Prius

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching