Will Custer LED Strobe Driver STR-QRLY Work with Load Resistors
Question:
I have a small trailer with two led running lights. I got them to work correctly on my Cayenne using your load resistors . If I was to add the strobe , would it be LED’s -LR’s - strobe or LED’s -Strobe- Load resistors? Or would it make a difference?
asked by: Brendan
Helpful Expert Reply:
Interesting question! My tech contact at Custer said their LED Strobe Driver # STR-QRLY should work just fine wired in upstream of the existing load resistors like # DI34ZR. So the wiring sequence would be strobe-resistor-LED.
Products Referenced in This Question
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Custer Single Function LED Strobe Driver - Quad Flash
- Accessories and Parts
- Emergency Supplies
- Vehicle Lights
- Strobe Driver
- Custer
more information >
Continue Researching
- Q&A: What is the Difference between the Hopkins Trailer Wiring Harnesses HM20041 and H20046?
- Q&A: Will Furrion Vision S Camera Kit Work with 34 Foot Trailer
- Q&A: What Size Pins are Needed to Install 5th Wheel Trailer Hitch to Husky Rails
- Q&A: Will Coiled Safety Cables Catch the Trailer Tongue Like Chains Would
- Q&A: Where does a Brake Flange need to be Welded on a Spindle
- Q&A: How Can I Get Trailer Lights to Flash when Disconnected from Truck
- Q&A: How to Get Separate Turn Signals and Brake Lights to Work on a Trailer
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide